Kdln EVITA Wall Lamp Turtledove Instruction Manual
- June 17, 2024
- kdln
Table of Contents
Kdln EVITA Wall Lamp Turtledove
Product Specifications
- Bulbs: 2 x 54W – T5 fluorescent or compatible LED light source
- Feeding: 220-240 V
Product Usage Instructions
Assembly Instructions
Follow the steps below to assemble the product:
- Open Box N.1 and Box N.2 to access the components.
- Refer to the provided manual for detailed assembly instructions.
- Ensure all parts are correctly aligned and securely fastened.
Dimmer Usage
To control the dimming of the lamp:
- Use the on/off button on the feeding cable.
- A quick, full pressure click turns the lamp on/off.
- Apply prolonged pressure to control the dimming effect.
- The electronic components memorize the last operation for convenience.
Contact Information
If you need further assistance or have questions, contact Kundalini at:
- Kdln Srl Viale L. da Vinci, 277 20090 Trezzano sul Naviglio, Milano
- Tel: +39 0236538950
- Email: [email protected]
- Website: kdln.it
Frequently Asked Questions (FAQ)
Q: How do I change the bulbs in the lamp?
A: To change the bulbs, follow these steps:
- Ensure the lamp is turned off and unplugged from the power source.
- Remove any covers or casings to access the bulbs.
- Unscrew the old bulbs and replace them with new ones of the same type and wattage.
- Reassemble the lamp and turn it back on to check the new bulbs.
Q: What should I do if the dimmer function is not working?
A: If the dimmer function is not working properly, try the following
troubleshooting steps:
- Check that the feeding cable is securely connected to the power source.
- Clean the dimmer switch and ensure there is no debris blocking its operation.
- If the issue persists, contact Kundalini customer support for further assistance.
ASSEMBLY INSTRUCTIONS
WARNING
- The safety is guaranteed by the appropriate use of the following instructions, so you must keep them.
- Always disconnect the main voltage before working on the appliance.
- Never use abrasive products or aggressive detergents for cleaning the lamp.
- If the external cable of this appliance is damaged, it must be replaced by the manufacturer, its after sales service or other equivalent qualified person only in order to avoid any danger.
- Kundalini will not provide a replacement until the nature of defect has been determined.
ASSEMBLY INSTRUCTIONS
BOX N.1
BOX N.2
Dimmer
The dimming of the lamp is activated using the on/off button on the feeding
cable. One quick, full pressure, click will turn the lamp on/off, a prolonged
pressure controls the dimming effect. The electronic components will memorize
the last operation and will alternately match the increase or decrease of the
light’s intensity with every click. 
- BULBS, 2 x 54W – T5 fluorescent or compatible LED light source
- FEEDING, 220-240 V
Kdln Srl Viale L. da Vinci, 277
20090 Trezzano sul Naviglio, Milano
T. +39 0236538950 [email protected]