INVENTUM AKB9005RVS Wall-Mount Cooker Hood Instruction Manual
- June 4, 2024
- INVENTUM
Table of Contents
- INVENTUM AKB9005RVS Wall-Mount Cooker Hood
- safety instructions
- INSTALLATION
- appliance description
- before the first use
- operating the appliance
- Cleaning and maintenance
- Troubleshooting
- Installation instructions
- TECHNICAL SPECIFICATIONS
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
INVENTUM AKB9005RVS Wall-Mount Cooker Hood
safety instructions
-
Please read these instructions before operating the appliance and retain for future use.
-
The appliance is intended solely for domestic use within the home. The appliance is suitable for extraction of air to the outside or for recirculation.
-
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance.
-
This appliance can be used by children aged 8 years and over, as well by people with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, provided they are supervised and instructed in the safe use of the appliance and understand the hazards involved. Do not allow children
to play with the appliance. Do not allow children to clean or maintain the appliance unless supervised. -
Life-threatening: danger of poisoning through backdating of combustion gasses!
• Never use the appliance to extract air while using a cooker that consumes air from the room, unless the room is sufficiently ventilated. Cooking appliances that consume air in the room (such as equipment that heats using gas, oil, wood or coal, geysers, hot water appliances) draw the combustion air out of the room and carry these gasses outside via the outlet (eg. shaft). In combination with an activated cooker hood, air is withdrawn from the kitchen and the adjacent rooms. This creates negative pressure if there is insufficient air supply. Poisonous gasses from the shaft or outlet channel are then back drafted into the living area. Always provide adequate ventilation! -
The maximum permitted negative pressure is 4 Pa.
-
Local regulations concerning the discharge of air have to be fulfilled.
-
The appliance is not intended to be operated by means of an external timer or separate remote control system.
-
Warning: Avoid the risk of electric shock; make sure the appliance is switched off before replacing the lighting or cleaning the appliance.
-
Do not use the cooker hood if the grease filter has not been fitted properly!
-
Do not lean against the cooker hood.
-
Never use the cooker hood as a working surface unless this is indicated explicitly.
-
If the cooker hood is used in combination with a gas hob ensure sufficient ventilation.
-
The outlet should not be connected to a flue duct used by other appliances.
-
Never flambé under a cooker hood and clean the filters on time. To prevent hot grease catching fire you should only deep fry under continuous supervision.
-
The cooker hood should be cleaned regularly both on the outside as well as the inside (at least 1 x a month). Insufficient cleaning or a delay in the replacement of filters can cause fire hazard.
-
The grease filters can become hot during use. After cooking wait at least 30 minutes before cleaning.
-
Please note! Intensive use can lead to condensation on the cooker hood. Condensation is simple to remove with a dry cloth.
-
Grease and oil are inflammable when overheated. Remain in the cooking area when preparing meals.
-
Fire danger! There is a risk of fire if the instructions for cleaning or replacing grease filters and/or carbon filters are not followed.
-
Fire danger! through grease deposits in the metal grease filter. Never work with open flame under the appliance (eg. flambéing). Always use the appliance with the metal grease filter. Clean the grease filter regularly.
-
Fire danger! through overheated grease or oil. Never extinguish a fire with water; always use a fire blanket, lid or plate.
-
The appliance may have sharp edges; please be careful during cleaning.
-
In relation with electrical safety, the appliance shall not be cleaned with high-pressure cleaners or steam cleaners.
INSTALLATION
- This appliance should only be connected by a registered installer.
- Always follow the installation instructions in the installation manual (chapter 7) provided.
- Check the appliance for transport damage. Do not connect a damaged appliance.
- Faulty parts may only be replaced by original parts. The manufacturer can only guarantee that original parts meet safety requirements.
- If the connecting cable is damaged, it may only be replaced by the manufacturer, the manufacturer’s service organization or equivalently qualified persons, in order to avoid dangerous situations.
- Always use the original cable and plug to connect the appliance.
- The electrical connection must comply with national and local regulations.
- The wall plug socket and plug should always be accessible.
- If you want to make a fixed connection, make sure that an omni polar switch with a contact separation of at least 3 mm is fitted in the supply cable.
- The appliance should not be connected to the mains via a multi-plug adapter or extension cable, as the safe use of the equipment cannot be guaranteed.
- Warning: Never open the appliance casing. The casing may only be opened by a service technician.
- Disconnect the appliance from the mains supply before starting any repair work.
- We advise to wear protective gloves when assembling the cooker hood because of the possible sharp edges.
- The distance between the lowest point of the cooker hood and the supported surface for the cooking pans gas hob should be at least 75 cm. With an electric, ceramic or induction hob this distance should at least be 65 cm.
- If the instructions of the gas hob specify a greater distance, this should be taken into account.
- Warning: failure to install screws or fixing devices in accordance with these instructions may result in electrical hazard.
- If the safety instructions and warnings are not followed, the manufacturer cannot be held responsible for any resulting damage.
- This appliance is intended to be used in household and similar applications such as:
- staff kitchen areas, in shops, offices and other working environments;
- farm houses and by clients in hotels, motels and other residential type environments; – bed and breakfast type environments;
- catering and similar non-retail applications.
- bed and breakfast type environments;
- catering and similar non-retail applications.
Legislation requires that all electrical and electronic equipment must be collected for reuse and recycling. Electrical and electronic equipment marked with the symbol indicating separate collection of such equipment must be returned to a municipal waste collection point.
appliance description
- Inner shaft
- Outer shaft
- Cooker hood
- Controls
- Metal grease filters – 3
- Lighting (LED spots 2 x 2.0W)
before the first use
Before you use the appliance for the first time, please do as follows:
Carefully unpack the appliance and remove all the packaging material. Keep the
material (plastic, polystyrene and cardboard) out of reach of children. Check
the appliance after unpacking for any damage, possible from transportation.
Place the appliance on a flat and stable surface.
This appliance should be installed and connected to the power supply by a
recognized fitter who is familiar with, and works according to the correct
safety regulations.
How to install the appliance, is instructed in the installation instructions
(chapter 7).
The appliance must be connected with a properly installed fused socket. The
power supply and voltage at the operating point must correspond with the
details on the rating label of the appliance.
EXTRACTION SYSTEM
This cooker hood can be connected in two ways: to a duct or as a recirculation
hood. Install the cooker hood according to the instructions, depending on your
choice.
VENT OUTSIDE – to a duct, the cooking vapours extracted by suction are carried
outside, once the grease particles have been filtered.
RECIRCULATE – as a recirculation hood, the grease particles and the smell in
the extracted vapours are filtered. The air that is sucked in is not carried
outside, but recirculates in the kitchen. A good out flow of the air is
necessary.
Extra information:
- Note: new houses may no longer vent outside.
- For recirculation, it is necessary to use carbon filters or a plasma filter. For more information on the differences between carbon and plasma filters check the website www.inventum.eu.
Attention! The starter kit for recirculation, carbon filters and plasma filter are not included. You need to order these separately.
operating the appliance
SWITCHING THE COOKER HOOD ON AND OFF
- Press 0 to turn the motor off.
- Press 1 and the motor runs at the lowest speed.
- Press 2 and the motor runs at the middle speed.
- Press 3 and the motor runs at the highest speed.
- Press and the lighting switches on. Press the button again to switch the lighting off.
Switch the lighting on if you need more light on your cooking appliance. It is recommended to operate the appliance a few minutes prior to cooking. Leave the appliance in operation for 5 to 10 minutes after the cooking is finished to remove all the smells from the kitchen.
Cleaning and maintenance
Before performing any maintenance operation, disconnect the cooker hood from
the mains power supply. Ensure that it is switched off and pull the plug or
remove the connector fuse.
Clean the in- and outside of the cooker hood regularly. Clean the cooker hood
with warm soapy water and a soft cloth. If your model is stainless steel,
clean it with a stainless steel care product. Do not use any abrasive cleaning
agents such as powder cleaners or cleaners that contain alcohol. Clean the
controls only with a damp cloth.
Attention: failure to carry out the basic cleaning recommendations can cause
fire risks.
GREASE FILTERS
A metal grease filter filters the grease particles in the air. Therefore, the
filter can get clogged, depending on the use. The metal grease filter does not
have to be replaced, but should at least be cleaned once a month. You can
clean it either by hand or in the dishwasher on a low temperature. Make sure
the grease filters are completely dry before placing them back. Do not use any
abrasive cleaning agents.
Not cleaning the grease filters on time can cause fire risks.
Cleaning the grease filters in the dishwasher can cause discoloration. This
has no effect on the operation.
REMOVING THE GREASE FILTER
Switch off the electricity! Remove the plug from the socket.
Pull the grease filter towards you and tilt it downwards at the front.
Make sure you guide the grease filter with your other hand to prevent the
grease filter from falling down on your cooking appliance.
REPLACING THE CARBON FILTERS
A carbon filter cleans the air and filters the smell that occurs during
cooking. A carbon filter can not be washed and reused. In all cases, it is
necessary to replace the carbon filter at least every four months.
- Remove the grease filters.
- Attach three carbon filters to the grease filters.
- Replace the grease filters.
CHANGING A LED SPOT
When a LED spot of the cooker hood is broken, you can replace it yourself. Follow these steps:
- Unplug the appliance or remove the connector fuse.
- Remove the grease filters and push the complete spot from the inside downwards – figure 1.
- Unplug the broken LED from the transformer – figure 2. Replace the complete LED with a matching type (2.0 W, LED L27A).
- Plug the new LED in the transformer and push the complete spot back in the housing of the cooker hood.
- Replace the grease filters and plug the appliance in.
Troubleshooting
What to do in case of a malfunction? In most cases, you will be able to
correct these faults easily yourself. Please check the solutions below before
contacting the Inventum service department.
The motor is not running
- Is it plugged in correctly?
- Is there a power outage?
- Check the electrical installation.
The performance of the cooker hood is not correct and makes more noise.
- Is the diameter of the exhaust-air pipe correct?
- Is the duct blocked?
- The diameter of the duct must be 150 mm. A smaller diameter can negatively influence the suction of the motor.
- Are the grease filters clean?
- Are the carbon filters not replaced within the last 6 months? Replace the carbon filters.
- Is there enough air supply to replace the extracted air?
Installation instructions
Read these installation instructions carefully before starting the
installation.
Decide whether there is a duct available or if the cooker hood needs to
recirculate. We advise installing the cooker hood with two persons.
- The minimum distance between the supporting surface for the cooking pans on the cooker and the lowest part of the hood must be:
- 65 cm for an electric, ceramic or induction cooker
- 75 cm for a gas hob
- If the cooker hood is to be fitted to an existing duct, no other appliances, such as a geyser or heater, may be connected to that same duct.
- The shorter the duct, and the fewer the bends in it, the better the cooker hood will work.
- The connection pipe for the cooker hood has a diameter of 150 mm.
ELECTRIC CONNECTION
Make sure the supply voltage ratings correspond with those stated on the
rating plate. Plug the appliance in. The cooker hood is provided with a plug.
Make sure the plug remains accessible. Place the socket, if necessary, out of
sight behind the exhaust-air pipe.
Attention: if you want to make a fixed connection, ensure that a multipole
switch with a distance between contacts of 3 mm is installed in the supply
cable.
TECHNICAL SPECIFICATIONS
| INVENTUM
---|---
Type| AKB9005RVS
Energy efficiency class [EEIcooker hood]| A
Lighting efficiency class| A
Grease filtering efficiency| D
Air flow rate (at min / max speed) [m3/h]| 250/645
Noise level at min / max speed [dB]| 50/69
Power consumption in the off-mode (Po) [W]| –
Power consumption in the standby-mode (Ps) [W]| –
Execution|
Color material| stainless steel
Number of motors| 1
Lighting| 2 x 2W
Number of aluminum grease filters| 2
Fitting carbon filter (not included)| KB93
Fitting plasma filter (not included)| IPF800R
Dimensions|
Width [mm]| 900
Diameter exhaust [mm]| 150
Technical specifications|
Power consumption [W]| 264 W
Rated voltage [V] / frequency [Hz]| 220-240V ~ 50Hz
References
- Inventum Huishoudelijke Apparaten - Altijd 5 jaar garantie!
- Inventum Huishoudelijke Apparaten - Altijd 5 jaar garantie!
- Inventum Huishoudelijke Apparaten - Altijd 5 jaar garantie!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>