DEVI 140F1134 Plug In Electronic Thermostat Installation Guide
- June 17, 2024
- DEVI
Table of Contents
DEVI 140F1134 Plug-In Electronic Thermostat
Introduction
DEVIreg™ Plug-in (140F1134) is an electronic thermostat to be installed indoors directly to a socket. The plug-in design makes it easy to install and connect ready-made cables with Schuko plugs like DEVIpipeheat 10 V2 or V3. Used primarily for controlling a lower temperature range as by frost protection. A wire sensor must be used to measure and control the desired temperature. The thermostat has a button to adjust the temperature setting, with a scale from +3° to +15°C. The LCD normally display the temperature. More information on this product can also be found at: www.devi.com
Technical Specifications
The product complies with the EN/IEC Standard “Automatic electrical controls for household and similar use”:
- EN/IEC 60730-1 (general)
- EN/IEC 60730-2-9 (thermostat)
Safety Instructions
Make sure the mains supply to the thermostat is turned off before
installation.
- Please also note the following:
- Always connect the thermostat to the continuous power supply.
- Do not expose the thermostat to moisture, water, dust, and excessive heat.
Mounting Instructions
Please observe the following placement guidelines: Do not place the thermostat
in a way that it will be exposed to direct sunlight.
Follow the steps below to mount the thermostat:
- Plug in the thermostat to a power supply socket.
- Place a wire sensor of the thermostat on a pipe that needs to be frost-protected (more information in the Pipe Frost Protection Application manual).
- Plug in a ready-made heating cable with a Schuko plug to the thermostat after completing the installation process for a heating cable and a wire sensor.
- Turn on the power supply
Warranty
A 2-year product warranty is valid for thermostats: DEVIreg™ Plug-in. Should
you, against all expectations, experience a problem with your DEVI product,
you will find that Danfoss offers DEVIwarranty valid from the date of purchase
on the following conditions: During the warranty period, Danfoss shall offer a
new comparable product or repair the product if the product is found to be
faulty because of defective design, materials or workmanship. The repair or
replacement.
The decision to either repair or replace will be solely at the discretion of
Danfoss. Danfoss shall not be liable for any consequential or incidental
damages including, but not limited to, damages to property or extra utility
expenses. No extension of the warranty period following repairs undertaken is
granted.
The warranty shall be valid only if the WARRANTY CERTIFICATE is completed correctly and by the instructions, the fault is submitted to the installer or the seller without undue delay and proof of purchase is provided. Please note that the WARRANTY CERTIFICATE must be filled in, stamped and signed by the authorized installer performing the installation (The installation date must be indicated). After the installation is performed, store and keep the WARRANTY CERTIFICATE and purchase documents (invoice, receipt or similar) during the whole warranty period.
DEVIwarranty shall not cover any damage caused by incorrect conditions of use,
incorrect installation or if the installation has been carried out by non-
authorized electricians. All work will be invoiced in full if Danfoss is
required to inspect
or repair faults that have arisen as a result of any of the above. The
DEVlwarranty shall not extend to products that have not been paid in full.
Danfoss will, at all times, provide a rapid and effective response to all
complaints and inquiries from our customers. The warranty explicitly excludes
all claims exceeding the above conditions. For full warranty text visit
www.devi.com.
devi.danfoss.com/en/warranty/
Disposal Instruction
This symbol on the product indicates that it may not be disposed of as
household waste. It must be handed over to the applicable take-back scheme for
the recycling of electri-cal and electronic equipment.
- Dispose of the product through channels provided for this purpose.
- Comply with all local and currently applicable laws and regulations.
Danfoss A/S
DEVI devi.com +45 7488 2222
EH@danfoss.com
Catingues descriptions, d/bertisementset. and extent, explicit reference is
made in a quotation or order confirmation. Danfoss cannot accept any
responsibility for possible errors in catalogues, brochures, videos and other
material. Danfoss
reserves the right to alter its products without notice. This also applies to
products ordered but not delivered provided that such alterations can be made
without changes to the form, fit or function of the product. All trademarks in
this material are property of Danfoss A/S or Danfoss group companies. Danfoss
and the Danfoss logo are trademarks of Danfoss A/S. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>