REED 04675 CPBVAC Bevel Boss Vacuum Adapter Instructions
- June 17, 2024
- REED
Table of Contents
POPE TOLS & VISES
SINCE 1896
CPBVAC Bevel Boss® Vacuum Adapter Instructions
Assembly and Mounting Instructions
-
Remove the adjusting ring by removing adjusting knob and washer.
-
Place the vacuum box over one of the three horizontal slots depending on the desired location.
If vacuum box does not fit in slots, see Special Instructions on reverse side. -
Place the band around the adjusting ring and attach to the vacuum box with the four screws.
Mount the adjusting ring back onto to the adapter. -
Attach operator’s own vacuum hose to vacuum box.
Special Instructions
If the vacuum box does not fit into the slots on the Bevel Boss®, follow the instructions below:
- Locate the two outer tabs as shown on on the figure.
- Place a flathead screwdriver between the tab and the outer edge of the vacuum box.
- Apply force to break off the tabs.
- Proceed with step 3 of Assembly and Mounting Instructions.
Reed Manufacturing
1425 West 8th St.
Erie, PA 16502 USA
Phone:800-666-3691 or
+1-814-452-3691
reedsales@reedmfgco.com
www.reedmfgco.com
0823-54676
Documents / Resources
| REED
04675 CPBVAC Bevel Boss Vacuum
Adapter
[pdf] Instructions
04675 CPBVAC Bevel Boss Vacuum Adapter, 04675, CPBVAC Bevel Boss Vacuum
Adapter, Bevel Boss Vacuum Adapter, Boss Vacuum Adapter
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>