OONO F-1067 On/Off Switching Electric Heating Relay User Guide
- June 17, 2024
- OONO
Table of Contents
OONO F-1067 On/Off Switching Electric Heating Relay
IMPORTANT !
- THIS MODULE OPERATES ON A HAZARDOUS VOLTAGE !
- All wiring must comply with national and local electrical code regulations.
- Installation should be carried out by an electrician.
- Disconnect power supply before installing the relay to prevent electrical shock.
Features
- The F-1067 Electric Heating Relay is designed to control a AC 240V line voltage resistive load from a low voltage thermostat. The F-1067 relay has a built-in 24 V transformer and is compatible with 3-wire (R, C, W) thermostats as well as 2-wire (R, W) mechanical and battery-operated thermostats.
- LED indicator for relay action. On a call for heat, the relay is immediately activated, there is no delay.
- Polycarbonate plastic enclosure, all wires lead out via 1/2” mounting nipple, it can be flexible mounting with your junction box / outlet box. Two screw mounting holes are convenient for you to fix it on the wall or wooden board.
- Packing list: 1x relay module, 1x NPT 1/2” Zinc alloy conduit locknut, 2x M3x50mm screws.
NOTE : Not recommended for fast-cycling modulated regulation. For fast- cycling heating equipment, you may muse use Solid State Relay.
Electrical Specifications
Voltage : 208 to 240 VAC
Resistive load : 22 Amp, Inductive load: 1.0HP/208V 1.5HP/240V, FLA: 12,
LRA: 42
Control signal : 24 VAC / 40 mA / 1.2 VA
Transformer ratings : 24 VAC / 1.2 VA / Class 2
Wire size : 12 AWG (red, black), 16 AWG (white, yellow, green, blue)
Ambient operating temperature : -20C to 60C Net weight: 6.7 oz (190 g)
DANGER !!!
- Do not open the housing in order to avoid the risk of electroshocks.
- This module operates on a dangerous AC voltage !
- All repairs should be executed by qualified technicians.
SAFETY INSTRUCTIONS !!!
-
Do not attempt to disassemble the unit as it does not contain any parts that are to be serviced by the user. (Tampering voids warranty)
-
Do not touch unused terminals when the module is connected to the AC power.
-
Handle the module gently and carefully. Dropping it can damage the circuit board and case.
-
Never exceed the protection limit values indicated in the specifications.
-
As safety requirement vary, please check with your local authorities.
-
Disconnect the module from the AC power before connecting new devices.
Wipe the device with a dry and clean cloth. Do not use detergents or other liquids that may damage the housing. -
Keep the device away from children.
-
Facilitate the operation of the device by familiarising yourself with its adjustments and indications.
-
CZH-LABS and Electronics-Salon modules are not suitable for use or as part of life support systems, or systems that might create hazardous situations of kind.
Typical Wiring Diagrams
-
Connection to a 2-wire low voltage thermostat
You must provide an overload protection and disconnect as required. -
Connection to a 3-wire low voltage thermostat
You must provide an overload protection and disconnect as required.
Dimensions
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>