LIAN LI GA II LCD FW Leading Provider of PC Cases User Manual

June 17, 2024
LIAN LI

LIAN LI GA II LCD FW Leading Provider of PC Cases

Product Information

The GA II LCD is a device that provides control and monitoring capabilities for your system, featuring a high-resolution LCD screen for displaying information.

Specifications

  • Model: GA II LCD
  • Release Date: 2024.01.08
  • Interface: USB Type C
  • Compatibility: Compatible with L-Connect 3 software

Product Usage Instructions

Step 1: Preparing for Firmware Update

  1. Ensure that your chipset driver & USB driver are up to date.

  2. Download the firmware update tool and extract the files.

  3. Turn off your PC.

  4. Disconnect the USB Type C Cable from the GA II LCD. If there is
    a SATA cable connected, remove it as well.

  5. Turn on your PC after 30 seconds.

Step 2: Executing the Firmware Update

  1. Run the executable file from the extracted firmware update tool.
  2. Check the box corresponding to GA II LCD and USB Type C.
  3. Plug in the USB Type C Cable of GA II LCD, and the firmware upgrade process will start automatically.
  4. Wait for the firmware update to be completed.
  5. Plug back the SATA cable of GA II LCD if it was disconnected.
  6. You can now control the GA II LCD using L-Connect 3 software.

FAQ

Q: When should I update the firmware manually?

A: You should update the firmware manually if the LCD screen remains stuck on the Lian Li logo screen after booting or if the firmware update progress stays at 0 for over 1 minute when using L-Connect 3.

GA II LCD FW manually update

If either of the following two situations occurs, please update the firmware manually:

  1. After boot, the LCD screen stays on the Lian Li logo screen and cannot be controlled with L-Connect 3.
  2. When using L-Connect 3 to perform firmware update, the progress remains at 0 for over 1 min.

Make sure that your chipset driver & USB driver is up to date before running all the steps

  1. Download this tool and extract
  2. Turn off your PC
  3. USB Type C Cable from GA II LCD, Remove SATA Cable(if there is one)
  4. Turn on your PC 30 sec later
  5. Execute file
  6. Check the box of
  7. Plug the USB Type C Cable of GA II LCD and the software will auto run the firmware upgrade
  8. Firmware update done
  9. Plug the SATA cable of GA II LCD (if there is one)
  10. You are now able to controller GA II LCD with L- Connect 3

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

LIAN LI User Manuals

Related Manuals