cecotec 2000 Outdoor Tower Heater Instruction Manual

cecotec 2000 Outdoor Tower Heater Instruction Manual

SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the device.
Keep this instruction manual for future reference or new users.
– Make sure the voltage of your mains supply matches the voltage requirements specified in the rating label of the appliance.
– When using electrical and electronic appliances, basic precautions must always be followed to reduce the risk of fire, electrical shock, and injury.
– This appliance is intended for outdoor use only.
– This device is designed for domestic use only and is not intended for bars, restaurants, farmhouses, hotels, motels, and offices.
– If the power cable is damaged, it must be replaced by the
Technical Support Service of Cecotec or similar qualified personnel to avoid risks.
– This symbol means “do not cover”.
WARNING: to avoid overheating, do not cover the appliance.
– The heating appliance must not be placed immediately below a socket outlet.
– Do not use the heating appliance in the immediate vicinity of a bath, shower, or swimming pool.
– Do not use this heating appliance if it has been dropped.
– Do not use if there are visible signs of damage to the heating appliance.
– Use this heating appliance on a horizontal and stable surface, or fix it to the wall, as applicable.
– Keep the device out of the reach of children under 3 years old, unless constantly supervised.
– Children between 3 and 8 years old should only switch the appliance on or off when it has been placed in its normal, intended operating position and if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children between 3 and 8 years old should not plug in, adjust, and clean the appliance and should not carry out maintenance tasks.
– WARNING: some of the product’s parts may become very hot and cause burns. Particular attention should be paid when children and/or vulnerable people are present.
– WARNING: do not use this heating device in small rooms that are occupied by people who cannot leave the room by themselves, unless permanent supervision is provided.
– WARNING: to reduce the risk of fire, keep textiles, curtains, or other flammable material at least 1 m away from the air outlet.
– Do not insert or allow objects to enter through the ventilation slots, as this may result in electric shock, fire, or damage to the appliance.
– Do not immerse the cable, plug, or any other non-removable part of the appliance in water or any other liquid. Do not expose the electrical connections to water. Always make sure that your hands are dry before operating or adjusting any switches on the product or touching the plug and socket.
– Never leave the device unattended during use.
– One of the most common causes of overheating is the building up of debris or fluff in the appliance. Be sure to clean these accumulations periodically by vacuuming the vents and grilles.
– Do not place the appliance on carpets, and do not place the cable under carpets. Position the cord in such a way as to avoid obstructing passage and cause tripping hazards.
– Do not store it until it cools down. Store it in a cool, dry place when not in use.
– Do not use the heater with a timer or any other device that turns the heater on automatically.
– WARNING: This heater is not equipped with a device to control the room temperature.

1. PARTS AND COMPONENTS

Heater (Fig. 1)

1. On/Off safety switch
2. Display
3. On/Off button
4. Timer
5. Protective grille
6. Heating elements

Remote control Fig. 2

1. On/Off button
2. Low power (650 W)
3. Medium power (1350 W)
4. High power (2000 W)
5. Timer

NOTE:
the graphics in this manual are schematic representations and may not exactly match the device.

2. BEFORE USE

– This appliance is packaged in a way as to protect it during transport. Take the device out of its box and remove all packaging materials. You can keep the original box and other packaging elements in a safe place. This will help you prevent damage to the device when transporting it in the future. In case the original packaging is disposed of, make sure all packaging materials are recycled accordingly.
– Make sure all parts and components are included and in good conditions. If there is any piece missing or in bad conditions, contact the official Cecotec Technical Support Service immediately.

Box content

1. Heater
2. Remote control
3. Instruction manual

3. OPERATION

Installation
Use four screws (M6*30) to fix the base to the bottom of the heater (as shown in the picture). Fig. 3

Operation instructions
A. These appliances must be supplied with the appropriate voltage and frequency, and connected to an individual electrical circuit, properly earthed, protected by a circuit breaker in accordance with wiring regulations. The power cord of this appliance must remain
attached. Installation may only be carried out by qualified personnel in order to avoid risks.
B. Only use the heater when it is in an upright position. This electric heater is equipped with a temperature setting. The switch at the top of the heater is used to control the 1500 W power settings. 0 position means off. Press the switch again so that the heater operates
at high power. This will cause both the lower and upper heating elements to ignite and radiate heat.

After turning the switch to ON position, press once; the display will show P0. The heater will enter standby mode.
– Press twice; the display will show P1. The heater will operate at 650 W.
– Press three times; the display will show P2. The heater will operate at 1350 W.
– Press four times; the display will show P3. The heater will operate at 2000 W.
– Press to select the timer function. The interval is 1-24 hours.

Remote control buttons
The heater functions can be controlled via the remote-control buttons and the LED display.
You can also control some of the functions of your heater via the buttons on the front of the it.

Remote control

1. On/off
   This button is used to switch the heater on or off or put it in standby mode.

2. Low power
   After switching on the heater, you can use this button to select the low power mode.

3. 3. Medium power
   After switching on the heater, you can use this button to select the medium power mode.

4. High power
   After switching on the heater, you can use this button to select the high- power mode.

5. Deactivate the timer
   Turn off the heater and start the standby mode.

4. CLEANING AND MAINTENANCE

Maintenance
– Switch off the appliance before servicing and allow it to cool down completely.
– To keep the device clean, the outer casing can be wiped with a soft, damp cloth. A mild detergent can be used if necessary. After cleaning, dry the unit with a soft cloth.
– DO NOT use alcohol, gasoline, abrasive powders, furniture polish or rough brushes to clean the cooker. This may damage or deteriorate the surface of the cooker.
– Although this appliance is approved for outdoor use (balconies and patios), it must not get wet for safety reasons. Wait until the appliance is completely dry before using it.

Storage
– Store the appliance in a safe, dry, and clean place if it is not going to be used during long periods of time.
– To prevent the accumulation of dust and dirt, use the original packaging to store the appliance.

5. TROUBLESHOOTING

– If the heater does not work, check the following before requesting repair:
– Check the main fuse for current.
– Make sure the switches are on. Otherwise, choose a power setting.

6. TECHNICAL SPECIFICATIONS

Product reference: 08264
Product: Ready Warm 2000 Power Tower
Rated voltage: 220 -240 V
Power: 2000 W
Frequency: 50/60 Hz

Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain

7. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES

This symbol indicates that, according to the applicable regulations, the product and/or batteries must be disposed of separately from household waste. When this product reaches the end of its shelf life, you should dispose of the cells/batteries/accumulators and take them to a collection point designated by the local authorities.
Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.

8. TECHNICAL SUPPORT AND WARRANTY

Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions, and deadlines established by the applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact the official Cecotec Technical Support Service at +34 963 210 728.

9. COPYRIGHT

The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or in part, be reproduced, stored in a retrieval system, transmitted, or distributed by any means (electronic, mechanical, photocopying, recording or similar) without the prior authorization of CECOTEC INNOVACIONES, S.L.

www.cecotec.es
Cecotec Innovaciones S.L.
Av. Reyes Católicos, 60
46910, Alfafar (Valencia), Spain
SF01230706

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>