soundmaster UR124 FM Pll Clock Radio Instruction Manual

soundmaster UR124 FM Pll Clock Radio Instruction Manual

ENVIRONMENTAL PROTECTION

Do not dispose of this product with the normal household waste at the end of its life cycle. Return it to a collection point for the recycling of electrical and electronic devices. This is indicated by the symbol on the product, user manual or packaging

The materials are recyclable according to their labeling. By reusing materials or other forms of recycling old devices and packaging, you are making an important contribution to protecting our environment. If necessary, remove batteries and personal data before disposal free of charge and ask your local authority about the responsible disposal point.

WARNING

Risk of electric shock Do not open!

Caution: To reduce the risk of electric shock, do not remove the cover (or back). There are no user serviceable parts inside. Refer servicing to qualified service personnel.

  This symbol indicates the presence of dangerous voltage inside the enclosure, sufficient enough to cause electric shock.

  **** This symbol indicates the presence of important operating and maintenance instructions for the device

Used batteries are hazardous waste and NOT to be disposed of with the household waste! As a consumer you are legally obligated to return all batteries for environmentally responsible recycling – no matter whether or not the batteries contain harmful substances*)

 Return batteries free of charge to public collection points in your community or shops selling batteries of the respective kind. Only return fully discharged batteries
*) marked Cd = cadmium, Hg = mercury, Pb = lead

 Only use mercury and cadmium-free batteries.

• Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
• Keep batteries away from children. Children might swallow batteries.
• Contact a physician immediately if a battery was swallowed.
• Check your batteries regularly to avoid battery leakage.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
• CAUTION: Danger of explosion if battery is incorrectly replaced
• Replace only with the same or equivalent type

WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

Safety, Environmental and Setup Instructions

• Use the device in dry indoor environments only.
• Protect the device from humidity.
• This apparatus is for moderate climates areas use, not suitable for use in tropical climates countries.
• No objects filled with liquids, such as vases, shall be placed on the apparatus.
• The mains plug or an appliance coupler is used as the disconnect device, the disconnect devices shall remain readily operable.
• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.
• Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
• A damaged mains cable or plug must immediately be replaced by an authorized service center.
• Use the device in dry indoor environments only.
• Protect the device from humidity.
• This apparatus is for moderate climates areas use, not suitable for use in tropical climates countries.
• No objects filled with liquids, such as vases, shall be placed on the apparatus.
• The mains plug or an appliance coupler is used as the disconnect device, the disconnect devices shall remain readily operable.
• Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.
• Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
• A damaged mains cable or plug must immediately be replaced by an authorized service center
• Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.
• Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer center.
• No naked flame sources, such as lighted candles, should be placed on the unit.
• When you are necessary to ship the unit store it in its original package. Save the package for this purpose.
• In case of malfunction due to electrostatic discharge or fast transient (burst), remove and reconnect the power supply.
• If the unit is not using for a long period of time, disconnect it from the power supply by unplugging the power plug. This is to avoid the risk of fire.

LOCATIONS OF CONTROLS

1. Wireless charging pad
2. SET / MEM / M+ button
3. < (backward) button

4. (forward) button

5. SNOOZE / SLEEP / DISPLAY DIMMER button
6. AL1 / AL OFF Alarm1 & volume down
7. AL2 / AL OFF Alarm2 & volume up
8. ON/OFF button
9. Wireless charging status indicator
10. Low battery indicator
11. Display
12.  Alarm 1 indicator
13. Alarm 2 indicator
14. DC In jack
15. Antenna
16. Battery compartment
17. Speaker

GETTING STARTED

CONNECTING TO POWER

• Connect the AC adaptor to a wall socket and to the DC IN jack.
• The radio is powered and in standby mode when you see the display is switched on.

BACKUP SYSTEM

• The radio is equipped with a backup system. It requires a 3 V lithium battery (type: CR2032 not included). Insert the battery into the battery compartment and make sure the positive and negative (+ or -) sides of the battery are in contact with the corresponding terminals in the battery compartment.
• If a power cut occurs, the radio automatically switches to the battery power supply and keeps the clock and timer settings.
• To open the battery compartment, use a screwdriver to detach the screw on the compartment door.
• The battery indicator lit when the battery should be replaced
• When replacing the battery, do not disconnect the power adapter. Otherwise, all clock and alarm settings will be lost.

SETTING THE CLOCK

• In standby mode, press and hold the “ SET / MEM / M+” button to enter the clock setting mode. The display flashes.
• Setting the time: Press the “>” button to set the hour time and “<” button to set the minute time.
• Press the “ SET / MEM / M+ ” button to confirm setting

USING THE ANTENNA
Unroll and extend the antenna to improve FM signal reception.

CONTROLLING THE SOUND VOLUME
While listening to the radio, press the “ ” or “ ” button to control the volume.

LISTENING TO RADIO

1. Press the “ON/OFF ”   button to switch the radio on.
2. Press the “<” or “>” button to adjust frequency.
3. Press and hold the “<” or “>” button to automatically tune to the next available FM station.
4. Press the “ON/OFF ” button to switch the radio off.

SETTING PRESET STATIONS
You can store up to 10 preset stations.

1. Tune to a station.
2. Press and hold the “ SET / MEM / M+ ” button until “P01” (or the next available preset slot) shows on the display.
3. Press the “<” or “>” button to select a preset number (P01-P10).
4. Press the “ SET / MEM / M+ ” button to confirm. The preset station has been set up.
5. Press the “SET / MEM / M+ ” button repeatedly while listening to the radio to select a preset station. Alternatively, press the “SET / MEM / M+ ” button once and then press the “<” or “>” button to select a preset station.

USING THE ALARMS

SETTING ALARMS
The radio lets you have 2 alarm settings. To set the alarms:

1. In standby mode, press and hold the “AL1 / AL OFF ” or “AL2 / AL OFF ”   button to enter the alarm time setting mode.
2. In the alarm setting mode, press the “AL1 / AL OFF ” or “AL2 / AL OFF ” button repeatedly to cycle through the setting options:

Alarm time > Alarm sound source

• Setting alarm time:
  Press the “>” to set the hour time and “<” button to set the minute time.
  Press and hold the buttons to change quickly.

• Setting alarm sound source:
  Press the “>” or “<” button to select buzzer (bu) or radio (last used frequency) as alarm sound source. The corresponding alarm indicator will turn on according to your selection.

Note: When the alarm is set to radio mode, the alarm will use the last tuned radio station.

TURNING THE ALARMS ON OR OFF
In standby mode, press the “ AL1 / AL OFF ” or “AL2 / AL OFF ” button to enable or disable the respective alarm. The corresponding Alarm 1 or Alarm 2 indicator will switch on when the alarm is enabled.

DEACTIVATING A SOUNDING ALARM

• Press any “AL OFF” button to switch off a sounding alarm.
• When the alarm sounds, the corresponding Alarm 1 or Alarm 2 indicator flashes on the display

SNOOZE

• To temporarily silence a sounding alarm, press the “SNOOZE / SLEEP” button. The alarm will sound again when the snooze period (9 minutes) is over.
• The corresponding Alarm 1 or Alarm 2 indicator flashes on the display during the snooze period.
• To cancel the snooze period and the alarm, press any “AL OFF” button.

SLEEP

• This sleep function defines the duration of time before the radio switches itself off automatically.
• When the radio is switched on, press the “SNOOZE / SLEEP” button repeatedly to select a sleep period (Options: OFF, 10, 20, 30, 40, 50, 60, 70, 80 and 90 minutes).
• The radio will automatically switch off when the sleep period is over.
• Press “SNOOZE / SLEEP” to check the remaining time before the radio switches off.
• Press “ON/OFF ” to cancel this function.

DISPLAY INFORMATION

• In radio mode, press the “<” or “>” button once to briefly change the display from the clock time to the current radio frequency.

DISPLAY BRIGHTNESS

• In standby mode, press the “DISPLAY DIMMER” button to change the brightness level of the display (off, low, medium or high).

WIRELESS CHARGING

Supports:

• Wireless charging phones (also works with plastic cases up to 3mm thick)
• Wireless earphones with wireless charging case Place phones face up on the wireless charging pad as pictured below.

Place phones face up on the wireless charging pad as pictured below

WARNING:
Remove metal protective or magnetic case from phone before charging. When charging phone, do not place magnetic-striped or other metal objects on the charger. Doing so could damage the object or this unit.

Check the wireless charging indicator on the clock display to monitor the charging status.

The LED lit green : Device is charging properly.
The LED becomes red : Device is charged.
The LED is red blinking: Device is not charging properly. Reposition device

Note:
When an iOS device is fully charged, the LED indicator light may remain lit. Radio reception may be limited during the charging process.

IMPORTER

Wörlein GmbH Tel.: +49 9103 71 67 0
Gewerbestrasse 12 Fax.: +49 9103 71 67 12
D 90556 Cadolzburg Email: service@soundmaster.de
Germany Web: www.soundmaster.de

The current instruction manual can be downloaded from www.soundmaster.de. Technical changes and misprints reserved. Copyright by Woerlein GmbH, 90556 Cadolzburg, www.soundmaster.de Duplication only with the permission of Woerlein GmbH

References

• soundmaster®
• soundmaster®

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>