DJI Phantom 3 Quadcopter with 4K Camera User Manual
- June 17, 2024
- DJi
Table of Contents
PHANTOM 3
Quick Start Guide
V1.0
3
Quadcopter with 4K Camera
Phantom 3 Quadcopter with 4K Camera
Phantom 3 4K
It’s time to meet your Phantom 3 4K.
The Phantom 3 4K’s camera records video at up to 4K and captures 12 megapixel
photos.
Review the diagram below for a full list of your Phantom 3 4K’s parts:
- Gimbal and Camera
- Vision Positioning System
- Camera Micro SD Card Slot
- Aircraft Micro USB Port
- Camera Status Indicator
- Front LEDs
- Motors
- Propellers
- Aircraft Status Indicators
- Antennas
- Intelligent Flight Battery
- Power Button
- Battery Level Indicators
- Link Button
- Camera Micro USB Port
Remote Controller
This powerful Remote Controller allows you to pilot and maneuver your Phantom
3 4K at distances over 3,940 feet (1.2 km)* away, while putting selected
camera controls at your fingertips.
Built into your Remote Controller is a rechargeable LiPo battery and Wi-Fi
video link, which when paired with a compatible mobile device gives you a live
HD view from the Phantom’s camera.
- Power Button
- Return to Home (RTH) Button
- Control Sticks
- Status LED
- Battery Level LEDs
- Power Port
- Mobile Device Holder
- Small Device Positioning Tabs (such as mobile phone)
- Antennas
- Handle Bar
- Gimbal Dial
- Camera Settings Dial
- Video Recording Button
- Flight Mode Switch
- Shutter Button
- Playback Button
- C1/C2 Buttons (Customizable)
- Micro USB Port
Here are the default flight
controls ( Mode 2 ). The left stick controls the aircraft’s altitude and
heading, while the right stick controls its forward, backward, left and right
movements. The gimbal dial controls the camera’s tilt.
* In a wide open area with minimal magnetic interference, and
at an altitude of about 400 feet (120 meters), the remote controller is able
to reach its maximum transmission distance – FCC compliant mode at 3,940 feet
(1.2 km) and CE compliant mode at 1640 feet (500 meters).
Using Phantom 3 4K
-
Download the DJI GO App
Search ‘DJI GO’ on the App Store or Google Play and download the app to your mobile device.http://m.dji.net/djigo
● The DJI GO app supports iOS 8.0 and Android 4.1.2, or later versions. -
Check Battery Levels
Press once to check the battery level.
Press twice and hold to turn on/off. -
Charging the Batteries
● When charging is complete, the battery and the Status LED will automatically turn off. -
Preparing the Remote Controller Press the button on the side of the Mobile Device Holder to release the clamp. Place your mobile device into the clamp and adjust it so that the mobile device is held securely in place.
-
Prepare for Takeoff
Activate your Phantom if you are using it for the first time. This requires an internet connection. Launch the app and tap Enter Camera View, then follow the on-screen instructions.
Tap the Aircraft Status Bar at the top of the screen and choose Calibrate. Follow the instructions to calibrate the aircraft’s compass.
Black propeller nuts go on motors with black dots.
Silver propeller nuts go on motors without black dots.
● Tighten the propellers with both hands before each flight. -
Flight
Safe to Fly (GPS)
Before taking off, ensure the Aircraft Status Bar in the DJI GO app indicates ‘Safe to Fly (GPS)’.
In the DJI GO App:
| Auto Takeoff
The aircraft will take off and hover at an altitude of 4 feet (1.2 meters).
---|---
| Return-To-Home
Brings the aircraft back to the Home Point. Tap again to stop the procedure.
| Auto Landing
The aircraft will land vertically and stop its motors.
● The aircraft will not avoid obstacles while it is returning to the Home
Point, and an appropriate RTH altitude MUST be set before flight. You should
also use the control sticks to guide the aircraft. Refer to the Safety
Guidelines and Disclaimer for more details.
Manual Takeoff
Manual Landing ● Never stop the
motors mid-flight, otherwise the aircraft will crash. Only stop the motors
when the aircraft is on the ground or as required in emergency situations to
reduce the risk of damage or injury.
- Fly Safe
DJI encourages you to enjoy flying in a safe, responsible and smart way. DO NOT FLY near or above people, near trees, power lines or buildings. DO NOT FLY in rain, snow, fog, and wind speeds exceeding 22 mph or 10 m/s.
DO MONITOR YOUR ALTITUDE and fly under 400 feet (120 meters).
DO MAINTAIN LINE OF SIGHT and avoid flying behind buildings or obstacles that block your view. It is important to understand basic flight guidelines, for the safety of both you and those around you. Refer to the Safety Guidelines and Disclaimer for more information.
No Fly Zones
More information at: http://flysafe.dji.com/no-fly
Specifications
● Aircraft
| Weight (Including Battery) | 2.82 lbs. (1280 g) |
|---|---|
| Max Ascent Speed | 5 m/s |
| Max Descent Speed | 3 m/s |
| Max Speed | 16 m/s (Atti mode, no wind) |
| Max Service Ceiling Above Sea Level | 19685 feet (6000 m) (Software altitude |
limit: 400 feet above takeoff point)
Max Flight Time| Approximately 25 minutes
Operating Temperature Range| 32° to 104° F (0° to 40° C)
GPS| GPS
● Gimbal
Controllable Range| Pitch: -90° to +30°
● Vision Positioning
Velocity Range| <8 m/s (Altitude 2 m)
Altitude Range| 50 cm to 300 cm
Operating Range| 50 cm to 300 cm
Operating Environment| Surface with clear pattern and adequate lighting (Lux >
15)
● Camera
Sensor| Sony EXMOR 1/2.3” Effective pixels:12.4 M (total pixels: 12.76 M)
Lens| FOV (Field Of View) 94° 20 mm (35 mm format equivalent) f/2.8
ISO Range| 100-3200 (video) 100-1600 (photo)
Electronic Shutter Speed| 8 to 1/8000 s
Image Max Size| 4000×3000
Still Photography Modes| Single shot
Burst shooting: 3/5/7 frames
Auto Exposure Bracketing (AEB): 3/5 bracketed frames at 0.7EV Bias Time-lapse
Video Recording Modes| UHD: 4K (4096×2160) 24/25p; 4K (3840×2160) 24/25/30p
FHD: 1920×1080 24/25/30/48/50/60p
HD: 1280×720 24/25/30/48/50/60p
Max Bitrate of Video Storage| 60 Mbps
Supported File Systems| FAT32 (≤ 32 GB); exFAT (> 32 GB)
Photo Formats| JPEG, DNG
Video Formats| MP4/MOV (MPEG-4 AVC/H.264)
Supported SD Card Types| Micro SD, Max capacity: 64GB. Class 10 or UHS-1
rating required
Operating Temperature Range| 32° to 104° F (0° to 40° C)
● Wi-Fi Video Link
Operating Frequency| 2.400 GHz – 2.483 GHz
Max Transmission Distance| FCC: 3940 feet (1200 m); CE: 1640 feet (500 m)
(outdoors and unobstructed, aircraft’s altitude at 400 feet (120 m))
Transmitter Power (EIRP)| FCC: 27 dBm; CE: 20 dBm
● Remote Controller
Operating Frequency| 5.725 GHz – 5.825 GHz, 922.7 MHz – 927.7 MHz (Japan Only)
Max Transmission Distance| FCC: 3940 feet (1200 m); CE: 1640 feet (500 m)
(outdoors
and unobstructed, aircraft’s altitude at 400 feet (120 m))
Operating Temperature Range| 32° to 104° F (0° to 40° C)
Battery| 2,600 mAh LiPo 18650 2S
Mobile Device Holder| Tablets and smartphones
Transmitter Power (EIRP)| FCC: 19 dbm; CE:14 dbm
Working Voltage| 300 mA @ 7.4 V
● Charger
Voltage| 17.4 V
Rated Power| 57 W
● Intelligent Flight Battery（PH3-4480 mAh-15.2 V )
Capacity| 4480 mAh
Voltage| 15.2 V
Battery Type| LiPo 4S
Energy| 68 Wh
Net Weight| 365 g
Operating Temperature| 14° to 104° F (-10° to 40° C)
Max Charging Power| 100 W
Download the user manual in the DJI GO app for more information.
※ This Quick Start Guide is subject to change without prior notice.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Designed by DJI. Printed in China.
©2015 DJI. All Rights Reserved
www.dji.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>