Waterpik Flexible Shower Head Instruction Manual

June 6, 2024
Waterpik

Waterpik - logoInstruction Manual
Model # is located by barcode.
Please write your model # on your sales receipt or below.
Model Number:
www.waterpik.com/shower-register
FN 20030583-F AA

You can view more information about Waterpik®’s shower head products at www.waterpik.com. To learn more about Waterpik ® water for wellness ® benefits go to www.waterpikwellness.com.
Note: pictures depicted may not directly illustrate your shower head.

PRIOR TO INSTALLATION

Waterpik Flexible Shower Head - pipe tape

  • Remove the old showerhead and remove all pipe tape.
  • Ensure that the washer from the old shower is not connected to the shower pipe. Use a thin utensil to check inside the shower pipe for washers, such as a pencil or screwdriver. Do not use your fingers.
  • No tools are needed for shower head installation.

INSTALLATION

Flexible Neck
Shower Head

  1. Waterpik Flexible Shower Head - Flexible NeckTighten the flexible shower arm onto the pipe by hand. Only use the nut to tighten. Do not use the flex arm. No Pipe Tape Needed.

  2. Attach the showerhead to the flex arm by hand tightening collar to the threaded end of the showerhead. Be sure to properly align threads before tightening.
    Waterpik Flexible Shower Head - properly align

OPERATION

Spray Selector:

Waterpik Flexible Shower Head - various spray Spray Selector allows you to select from various spray patterns. On some models, the spray pattern is controlled by the small lever that rotates left and right. On some models, the spray pattern is controlled by a push-button which allows you to select either the full-body spray or the concentrated power spray. To change the setting, push the button at the base of the showerhead so that it extends to the opposite side of its current position.

WARNINGS:

  • To avoid hot water dangers and conserve even more energy, make sure your water heater is set at 120°F (48.9°C) or below.
  • Test the tub/shower water with your hand before bathing.
  • For additional safety for Ecoflow® or high-efficiency showerheads, it is recommended that all homes have installed a pressure balance tub and shower valve with the rotational limit stops properly set by a plumber. If you are unsure of your valve type consult your plumber.
  • For external use only. The potentially deadly amoeba, Naegleria fowleri, may be present in some tap water or unchlorinated well water.

CARE AND CLEANING

  • To maintain proper working conditions cleaning is required when mineral deposits appear on the spray orifices. To clean mineral deposits, gently rub the rubber nozzles on the face of the showerhead to dislodge.
  • To clean heavier deposits, remove the showerhead and soak face down in 1-2 cups of white vinegar (use white vinegar only) for about 2-3 hours. Replace the shower head and run in each mode to flush out the vinegar.
  • Do not clean or rinse any part with harsh chemicals, heavy-duty cleaners, or abrasives; this may damage parts or finish and will void the warranty.
  • Clean filter screen by unscrewing from the flex arm nut and rinse by back flushing to remove particles. Follow steps 1-2 under installation to reinstall shower head, making sure washer is re-seated on top of the filter screen.

TROUBLESHOOTING GUIDE

Problem|

Solution

---|---
No water flow from the installed shower head.| a Confirm previous shower washer is not in the shower pipe.

b, Confirm there is only one washer in the nut.

Low water pressure or missing spray patterns.| a Clean shower head in vinegar/water solution. (See care & cleaning section).
b Clean filter screen.
Leaking at large nut connection.| a Confirm only one washer is seated on top of the screen.
b Grate bar of soap across the shower pipe threads to act as a sealant.
c Confirm filter screen is firmly seated in a nut.

FOR USA ONLY
Limitation of Liability: This limited warranty is your sole remedy against Water Pik, Inc. and it shall not be liable for any damages, whether direct, indirect, incidental, special, consequential, exemplary, or otherwise, including but not limited to property damage, arising out of any theory of recovery, including statutory, contract or tort.

BINDING ARBITRATION AND WAIVER OF RIGHT TO ASSERT MATTERS IN COURT AND RIGHT TO JURY TRIAL
By purchasing, installing, or using this product you agree that any controversy or claim arising out of or relating to your purchase, use, modification, installation, or removal of this product shall be settled by binding arbitration. The arbitrator’s decision will be final and binding. Judgment on the award rendered by the arbitrator may be entered in any court having jurisdiction over the matter. Further, you agree that you will not have the right to litigate any claim arising out of or in relation to your purchase, use, modification, installation, or removal of this product in any court or to have a jury trial on that claim. Arbitration of any matters shall be administered by the American Arbitration Association and conducted by one arbitrator in accordance with the consumer arbitration rules of the American Arbitration Association in effect at the time of filing of the demand. The venue for all such arbitrations shall be Colorado and any such arbitration shall be subject to the Federal Arbitration Act and Colorado law.

WAIVER OF RIGHT TO PARTICIPATE IN CLASS ACTIONS OR PURSUE CLAIMS IN A REPRESENTATIVE CAPACITY.
Further, by purchasing, installing, or using this product you agree that arbitration must be on an individual basis. This means neither you, nor we may join or consolidate claims in arbitration by or against other purchasers or users of Water Pik, Inc. products or the general public. Additionally, you may not litigate in court or arbitrate any claims as a representative or member of a class or in a purported representative capacity on behalf of the general public, other purchasers or users of this product, other persons or entities similarly situated, or in a private attorney general capacity. If the product malfunctions or becomes damaged, stop use and contact Water Pik, Inc. for assistance. Have any questions or need assistance? For quick service prior to calling have your model number and receipt ready.

In the U.S., call our toll-free
Customer Assistance Line
1-800-525-2774, Monday – Friday, 7:00 AM – 5:00 PM MST.
or visit www.waterpik.com
In Canada, call our bilingual tollfree
Customer Assistance
Line 1-888-226-3042,
Monday – Friday, 7:00 AM – 5:00 PM MST.
or visit www.waterpik.ca

© 2021 Water Pik, Inc. Printed in China.

Water Pik, Inc., a subsidiary of Church & Dwight Co., Inc.
1730 East Prospect Road
Fort Collins, CO 80553-0001 U.S.A.
www.waterpik.com

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Waterpik User Manuals

Related Manuals