waterpik WP-862 Water Flosser and Triple Sonic Toothbrush User Guide
- June 17, 2024
- Waterpik
Table of Contents
water flosser®
QUICK START GUIDE
Review full instruction book prior to first use
FIRST USE
Fill reservoir with warm water and replace it firmly on the base.
Insert tip firmly until it clicks into place.
Turn pressure to high, point tip into sink, turn power and water switches on until water flows. Then turn off.
START WATER FLOSSING
TO AVOID MESS: PLACE THE TIP IN YOUR MOUTH BEFORE TURNING UNIT ON
Turn power and water on.
Start on low pressure and increase to your liking.
LEAN OVER SINK
Close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink.
TECHNIQUE
Aim water at the gumline at a 90° angle. Follow the gumline and pause briefly between teeth.
HOW TO VIDEO
Visit waterpik.com/vid860
Register your product and receive over $50 in savings.
waterpik.com/registration
Model WP-860/861/862/871/872/881/882
This device is only compatible with voltages of 120 VAC, 60Hz
© 2017 Water Pik, Inc.
1.800.525.2774 (USA)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>