waterpik WP-450 Ultra Cordless Water Flosser User Guide
- June 17, 2024
- Waterpik
Table of Contents
waterpik WP-450 Ultra Cordless Water Flosser
Model WP-450/455/460/462
QUICK START GUIDE
-
Charge Unit for 24 Hours Prior to First Use.
Turn power switch OFF, plug power cord into outlet, and insert the charging cord into the unit. -
Insert Tip : Select the appropriate tip and insert into the unit. Press firmly until the tip clicks into place.
To remove tip, push the tip eject button. -
Fill the Reservoir:
Unplug charging cord from unit prior to filling with water and during use. Lift the flip top on reservoir and fill with lukewarm water. Refill as needed -
Usage: For first time use, adjust the pressure setting to the LOW setting.
This device is only compatible with a voltage system of 120VAC, 60Hz. Do not plug this device into a voltage system that is different. -
On/ Off Procedure:
Always place tip in mouth before turning unit on. Lean over sink and close lips enough to prevent splashing, while still allowing water to flow from mouth into the sink. Turn unit ON. -
Technique Tips for Best Results : Aim the water stream just above the gumline at a 90 degree angle.
- Starting with the back teeth, follow the gumline and pause briefly between teeth.
- Continue until all areas around and between teeth have been cleaned.
-
REGISTER YOUR PRODUCT ONLINE NOW!
Receive up to $44 in savings on the purchase of additional Waterpik® products www.waterpik.com/registration
Water Pik, Inc. 1.800.525.2774 1730 East Prospect Road, Fort Collins, CO 80553-0001 USA
- www.waterpik.com ©2014 Water
- Pik, Inc. FN 20019052-F AA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>