OKIN REFINED JLDK-56 Wireless Charger User Manual
- June 17, 2024
- OKIN REFINED
Table of Contents
OKIN REFINED JLDK-56 Wireless Charger
Product Information
Specifications
- Product Name: JLDK-56
- Appearance: Please refer to the dimension drawings
- Product Features:
- Line controller
- 1-button switch to control 1 drive
- Designed for chairs
- Wireless charge
- Performance Data:
- Cable: 5 pins, round plug, 1500 mm
- Wireless charging output current: 1.5A~1.8A
- Wireless charging output voltage: 8.5V~10V
- Input voltage: 29V
- Input Environment: Indoor use
Connection Diagram
Product Usage Instructions
FAQ
Q: My sofa doesn’t work.
A:
- Check your sofa by following these steps:
- Check the SMPS light:
* If the SMPS light is on, the system works.
* If the SMPS light is off, check for any disconnections. If all items are connected properly but the light is still off, replace the SMPS and retry.
2. Press a switch key and check the LED light:
* If the LED light is on, the system works.
* If the light is on but the sofa still doesn’t work, replace the switch or the actuator as the circuit may be the major cause of the fault. Also, check for any disconnections or cuts or crimps in cables.
* If the LED light is off, check the SMPS. If the SMPS works, replace the switch.
Product’s Appearance
Dimension Drawings
Product Features
- Line controller
- 1-button switch to control 1 drives
- Designed for chairs
- wireless charge
Performance Data
- Cable: 5 pins, round plug, 1500 mm
- Other data is shown in the following table
Maintenance Instructions
-
Please do not use non-waterproof products in damp environments. No products are allowed to be washed with water. Cleaning with alcohol is allowed.
-
Please handle the product with care and install it properly to avoid any breaks in plastic material or in small components.
-
Please follow the specifications and eliminate insecurities in time. Overload is not allowed.
-
Ambient temperature: room temperature.
-
Relative humidity: no more than 80%.
-
Please pay attention that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: -
This device may not cause harmful interference
-
This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>