cablematic ve11000-01 Stand Fan Instruction Manual
- September 2, 2024
- CABLEMATIC
Table of Contents
clematis ve11000-01 Stand Fan
Read this manual carefully before using the device and save it for future reference. To reduce the possible risk of fire, electric shock, or personal injury, keep in mind the following instructions:
GENERAL INFORMATION
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given appropriate supervision or training concerning the use of the appliance in a safe and They understand the dangers involved. Children must not play with the appliance. Cleaning and maintenance to be carried out by the user must not be carried out by children without supervision.
- If the power cord is damaged, it must be replaced by the manufacturer or by a qualified technician to avoid the risk of electric shock.
- Before operating this appliance, read the following instructions. Keep the manual in a safe place so you can consult it at any time.
- After removing the packaging, check that the appliance is in good condition, and if you have any questions, do not turn it on.
- Contact your distributor or seller for the return of the appliance.
- This device is packed for protection against any damage or damage that may be caused by transportation.
- The packaging is made up of plastics and other materials that can be dangerous. Keep out of reach of children.
- These materials are recyclable and must be delivered in a unit of the appropriate recycling, respecting the environmental laws.
- This appliance has been designed for DOMESTIC USE only and must not be used with any other appliance, such as in a commercial, industrial, or any other non-residential installation.
- Do not handle the appliance with wet hands and do not immerse it in water or any other liquid.
- Unplug the appliance from the mains before cleaning it.
- Do not continue using the appliance if you notice that it is not working properly.
- Turn it off immediately and look for the manufacturer or an authorized technical service so that a qualified technician can evaluate the damage and repair it if necessary.
- Turn off the appliance and disconnect the power cord from the power outlet before replacing any part or accessory, or before touching the moving parts of the device.
- Connect the device only to an AC power source. The voltage indicated on the rating plate that is on the device, must match the voltage of the power supply.
- Always disconnect the appliance from the socket after use, to disassemble or clean it.
- Always mount and use the appliance on a stable and secure surface.
- Never place the appliance on or near heat sources, such as a gas/electric stove or inside a hot oven. Keep the power cord away from these sources of heat or sharp objects.
- Never handle the power cord with wet hands.
- The use of accessories or parts not recommended by the manufacturer may cause a fire, an electric shock, or serious injuries.
- This device is manufactured to be used indoors. Never use it outdoors or in outside parts of the house.
FEATURES
- Power: 45W
- Speeds: 3 levels
- Fixed or oscillating position
- security grill
- Blade diameter: 40cm
- Heights: min.100 – max.120cm
- Oscillating
FAN PARTS
- Grid retaining ring
- Front of the grille
- Propeller fixator
- Propeller
- Grid holder
- Back of the grid
- Engine
- Dashboard
- Oscillation regulator
- Fixing screw
- Telescopic top tube (chrome)
- Fixing ring
- Telescopic lower tube (white)
- Cover
- Foundation
ASSEMBLY INSTRUCTIONS
- Remove all packaging carefully, and avoid scratching plastic covers with scissors or knives.
- Assemble the base of the fan, joining it to the lower telescopic tube.
- Place on the motor shaft following the following order: the rear part of the grille, the propeller, and the front part of the grille using the corresponding nuts and washers to hold the parts together as shown in the upper diagram.
- To fix both grids use the ring, and fix it with the security screw.
- Finally, insert the part of the propeller with the motor into the telescopic tube and then use the fixing screw to hold it all.
RUNNING
Through the 3-speed system you can start the fan, this system is designed
to give you maximum flexibility. You can also activate the oscillation
function using the oscillation slider.
- POSITION 0: OFF position, no button pressed.
- POSITION 1: first gear
- POSITION 2: second gear
- POSITION 3: third gear
- SWING: swing button set direction (num.9)
IMPORTANT NOTES
- Place the fan on a flat, dry surface.
- Before connecting the device to the network, make sure that the switch is in the “0” position.
- Plug the power cord into the outlet 220-240V~ 50/60Hz
- If you do not use the fan for a long time, please unplug the power cord from the outlet.
- Never try to disassemble the device where the motor is located.
- If you notice any abnormality (such as unusual fan noise), turn off the device and unplug it immediately.
- Make sure that no objects or liquids enter the interior of the fan through any openings.
- The fan should only be used in dry environments.
- Protect the device from dust, moisture, sunlight, and direct heat.
CLEANING AND MAINTENANCE
- Make sure the appliance is unplugged before cleaning.
- Clean with a soft damp cloth, without detergent, aggressive liquids, or solvents.
- Do not immerse the fan in water or any other liquid.
- If the fan is not going to be used for a long period, protect it and store it, or after cleaning, in a dry place.
WASTE
This symbol on the product or in the instructions means that your electrical
and electronic equipment must be disposed of at the end of its useful life in
a specialized container; Do not dispose of it in the usual household waste
container. In the EU there are special waste collection systems for subsequent
recycling. For more information, contact the local authority or the retailer
from whom you purchased the product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>