Opove H5 RECHARGEABLE HAIR CLIPPER USER MANUAL

Opove H5 RECHARGEABLE HAIR CLIPPER

Product Parts

1. Blade
2. Micro Length Regulator
3. Rotary Speed Control
4. Power On / Off
5. LCD Screen
6. Power Adapter
7. Oil Refill Reminder
8. Load Condition Display
9. Spinning Motor
10. Rotary Motor
11. Remaining Time
12. Current Micro Length

Accessories

Product Specifications

Recharging

• Connect the power base into the circuit.
• Connect the power adapter to the power base.
• Ensure the power is “off” and place the clipper on the power base and make “didi” sound.
• LCD screen light will blink to indicate that it is charging. (The hair clipper will activate recharging protection after fully charged. Turn off charging power, and protect the battery lifetime).

Note

• The clipper can directly charge with the power base.
• The hair clipper can be operated with the cable when it is out of battery.

Recharging Instructions

• Please charge the clipper at least 3 hours before using it for the first time.
  After 3 to 4 times, the battery capacity will reach its best conditions.

• The best temperature to operate the hair clipper is between room temperature 5°C to 40°C.

• The product will still maintain 80% of the battery capacity after 400 times the battery cycle.

Features

Chart for Micro Length regulator

Reminder Lubricant Oil Refill Features
When the hair clipping operation accumulate over 120 minutes, the “oil” ( ) symbol will blink and beep to remind you to clean the blade and refill the lubricant oil.

Burden Condition

When the burden is shown as the above picture, it is normal.

When the burden is shown as the above picture, the loading condition is higher, and need to is lubricant oil on the blade.

When the burden is shown in the above picture, the hair clipper will be beeping and warning the burden condition very higher than normal. Need to remove the blade for cleaning and refill the lubricant oil immediately.

Rotary Control Features

• The number displays the rotary times of hair clippers in each minute.
• Rotary frequency: 5000 – 7000 times in every minute.
• Rotary setting: Press “-” or “+” to adjust the rotary regulator to specific spin, and each adjustment is 500 spins apart.

Smart Rotary Features

• Hair clipper will remain the same speed as set.
• The highlight of this product is the rotary speed will not be affected when cutting a lot of hairs or thicker hair during operation. It will remain the same speed of the rotary; increasing the cutting process and cutting result.

Current Remaining Time Display

Display the current battery remaining time, the below times based on when the battery is fully charged.

min

| 235

min

| 220

min

| 205

min

| 190

min

Micro cutting Length Setting
Setting for 4 micro cutting lengths: 1.0mm, 1.3mm, 1.6mm,1.9mm.

Charging Reminder

When the battery remains 20 minutes, the battery symbol will start blinking, and making a “didi” sound to remind you to recharge the clipper.

Installation and Detachment

1. Trim comb installation
   Press and pulls the trim comb into the clipper shown as picture 1. (Caution: locks clipper into place to prevent any movement or fall off)

2. Trim comb detachment
   Pull in the opposite direction of the installation and detach the trim comb shown in Picture 2

3. Blade detachment
   Press and use a thumb to slide off the blade.

4. Blade installation
   Press the blade and locked into its place until hearing a “click”.

Cleaning & Maintain

• Use a brush to clean the hair between the inner cutter and the clipper. (Do not remove the blade spring, which may cause damage).
• Drop 1-2 lubricant oil on the blade (shown as the picture) after cleaning, and reinstall the blade back to the clipper.
• The blade could be rinsed with water after it detached, please keep it dry before refilling the lubricant or installation.

Product List

The product list contains:

• Hair Clipper x1
• Power Base x1
• Power Adapter x1
• Cleaning Brush x1
• Trim Comb x8

Caution

• Do not disassemble the product without the seller’s permission.
• Do not keep the clipper in a humid place or wash it directly with water.
• Product can only be wiped with wet cloth or with soap water for cleaning.
• Do not recharge the product when the room temperature is above 40°C or below 0°C.
  Note
  Normally, the product will during recharging or operation.

Battery Removal

• Disconnect the clipper from the power adapter.
• Operate the item until out of battery.
• Unscrew the clipper (shown as picture) and remove the battery.
• Be careful the battery cannot be used after removal, the positive and negative pole may cause short-circuit.
  Note
  The internal battery is a lithium battery. Please take out the battery before dispose the item. Use recovery and disposal of waste electrical guideline in order to protect the environment.

Warranty Card

Year

Consumer

| ****

Address

|  | Name|
---|---|---|---|---
Phone number|

Retailer

| Address|  | Name|
Store name|  | Phone number|

Note
Warning : This product cannot be used to cut animal hair. The company will not be responsible for any damage of the hair clipper or provide any compensation if the animal gets hurt from using the hair clipper.

Product Warranty:

• The product was made under strict quality control and inspection.
• 30-day Unconditional Money back! 1-year warranty covers failures due to defects in materials or workmanship that occur during normal use. (Blade needs to buy)
• Possible charges under warranty:
  • (a)Any defects under improper usage.
  • (b)Any damage due to improper repair or modify the clipper in any way.
  • (c)Failures that result from natural accident.
  • (d)Failures of misuse damage or modification.
  • (e)Failures of line power surge.
  • (f)Any damage caused by not following the instruction manual.

www.opove.com

FAQs

What is the Opove H5 Rechargeable Hair Clipper?

The Opove H5 Rechargeable Hair Clipper is a cordless grooming tool designed for cutting and styling hair.

What are the key features of the Opove H5 Hair Clipper?

The key features of the Opove H5 include a rechargeable battery, adjustable cutting lengths, stainless steel blades, and various attachments for precise hair cutting.

How long does it take to fully charge the Opove H5 Hair Clipper?

It typically takes about 2 to 3 hours to fully charge the Opove H5 Hair Clipper.

What is the runtime of the Opove H5 on a full charge?

On a full charge, the Opove H5 can provide approximately 3 to 4 hours of runtime, depending on usage.

Does the Opove H5 Hair Clipper come with different cutting length options?

Yes, the Opove H5 includes various attachment combs that offer different cutting length options to accommodate different hair styles and lengths.

Are the blades of the Opove H5 sharp and durable?

Yes, the Opove H5 Hair Clipper features high-quality stainless steel blades that are sharp and designed for long-lasting performance.

Is this clipper suitable for both wet and dry hair cutting?

The Opove H5 Hair Clipper is primarily designed for dry hair cutting, but it can handle some light wet cutting, such as damp hair.

Can the Opove H5 Hair Clipper be used for body grooming as well?

While it is primarily designed for haircutting, the Opove H5 can be used for some body grooming tasks.

Yes, the Opove H5 Hair Clipper is designed for easy cleaning. You can remove the blades and rinse them under running water for maintenance.

Can I use this clipper while it's charging?

Most cordless clippers, including the Opove H5, allow for corded use while charging. Refer to the product manual for specific instructions.

Is the Opove H5 Rechargeable Hair Clipper suitable for all hair types?

The Opove H5 is designed to work well with various hair types and can be adjusted to different lengths to accommodate different hair textures and styles.

Download This Manual PDF:Opove H5 RECHARGEABLE HAIR CLIPPER USER MANUAL

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>