FelixKing FK936-H Office Desk Chairs Instruction Manual
- June 17, 2024
- FelixKing
Table of Contents
FelixKing FK936-H Office Desk Chairs
Instructions for Use
- Thanks for purchasing our products. Please read this manual before assembly.
- And please assemble in order. After the assembly, keep the instructions properly.
- Make sure all the parts are included (16 kinds in total).
Accessories List
- Notice If any questions, contact FelixKing-service@outlook.com / FelixKing-Spt@outlook.com]
- This is a single chair, so please do not seat 2 or more persons, just seat only one person.
- Do not stand on the chair.
- Do not sit in reverse or sit outside of the seat cushion.
- Check the screws once every 6 months, to make sure the screws are tight.
- Do not use the chair when the screws are loose.
- Please assemble according to the instructions.
Assembly Instruction
Please assemble in a wide and flat place.
Step 1
- Insert 5 Foot Stool (4) into the central base tube as shown. Align with the holes on both sides, tighten 10 Screws M6X12mm (12) with Hexagon Wrench (13).
Step 2
- Insert the 5 Castors (5) into the footstool installed in step one and press them in firmly. Put Air Rod (6) into the hole of the central base tube as shown.
- Then put it aside and we will use it in Step 6.
- Caution: Confirm Castors (5) must be inserted deeply. Otherwise, the Castors could easily fall out and the chair could fall.
Step 3
- Tighten the Screws M6X35mm (9) with Hexagon Wrench (13) to fix 2 Armrests(7) to the back of the Backrest(2). Tighten the 4 screws firmly and then cover the screws with Decoration Caps (14).
Step 4
- After Step 3, fix the bottom of the Armrests (7) to the back of the Seat Cushion (3). Tighten the Screws M6X35mm (9) and Gaskets (15) with Hexagon Wrench (13) firmly.
Step 5
- Fix the Base Plate (8) to the bottom of the Seat Cushion (3).
- Tighten the Screws M6X18mm (10) with Hexagon Wrench (13) firmly.
Step 6
- Pick up the Step 2’s Air Rod (6) and Foot Stool (4). Insert the Air Rod (6) into Step 5’s Base Plate (8). There’s a hole in the middle of the Base Plate (8).
- Press the Seat Cushion (3) from top to bottom, use your whole body’s strength to insert it firmly.
- Then, align the Headrest(1) with the screw holes on the top of the Backrest(2), tighten the 2 screws M6X20mm (11) firmly, and then cover the screws with
- Decoration Caps (14), the assembly is complete now.
- Caution: If the Air Rod (6) isn’t inserted into Base Plate (8) firmly, it’s likely to fall when the chair raises.
Activate Your Warranty Now!
- We guarantee you a pleasant buying experience. Please scan the QR code to activate your warranty, so that you can enjoy priority and better after-sales service.
- After-Sales Phone Number: +1 209-564-9545
- Scan the QR code to watch the installation video.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>