Fellowes P-35C Powershred Cut Shredder Instruction Manual
- June 17, 2024
- Fellowes
Table of Contents
POWERSHRED® P-35C
THE WORLD’S TOUGHEST SHREDDERS™
P-35C Powershred Cut Shredder
Please read these instructions before use.
Do not discard: keep for future reference.
KEY
A. Shredder head
B. Sheet capacity icon
C. See safety instructions below
D. Bin
E. Safety lock
F. Disconnect power switch| G. Handle
H. Paper/Card entry
I. Control Switch
R 1. Reverse
0 2. Off
I 3. Auto-On
---|---
SET UP
Disconnect power switch must be in ON (I) position to operate shredder.
For safety reasons, shredder will operate only if the shredder head is in
correct position and used with supplied basket.
CAPABILITIES
Will shred: Paper, credit cards, staples, and small paperclips
Will not shred: Unopened junk mail, continuous forms, adhesive labels,
transparencies, newspaper, CD/DVDs, cardboard, large paper clips, laminates,
file folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut ………………………………… 4 x 40mm
Maximum:
Sheets per pass ……………………………………5
Cards per pass ………………………………….1
Paper width …………………………….222mm
- 70g A4 paper at 220-240v, 50Hz, 0.8Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 10-20 paper passes; 10 cards.
WARNING
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
- Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.
- Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.
- Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.
- Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water.
- **** Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.
- This shredder has a Disconnect Power Switch (F) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.
- Avoid touching exposed cutting blades under shredder head.
- Shredder must be plugged into a wall outlet or socket of the voltage and amperage designated on the label. The outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
- FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
- For indoor use only.
OPERATION
Continuous operation: 3-minute maximum
NOTE: Shredder runs briefly after each pass to clear entry.
Continuous operation beyond 3 minutes will trigger 30 minutes cool down
period.
Safety Lock prevents accidental operation. To set, wait for shredding to stop, set control switch to Off (O) position, then slide black button down.
Tounlock,slideblackbuttonup.Forgreatersafety,alwaysunplugshredderafteruse.
TROUBLESHOOTING
Paper jam: Set to Off (O), lift head and empty bin. Replace head on bin and follow any or all of the below procedures.
Shredder doesn’t start:
Make sure switch is in auto position (I).
Make sure safety lock is in unlock position.
Make sure head is on basket correctly. Check for jam.
Remove and empty basket.
Wait 30 minutes for motor to cool down.
MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusivenoise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
CAUTION
*Only use a non-aerosol vegetable oil in long nozzle container such as
Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 1 year from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 3 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.
W.E.E.E.
This product is classified as Electrical and Electronic Equipment. Should the
time come for you to dispose of this product please ensure that you do so in
accordance with the European Waste of Electrical and Electronic Equipment
(WEEE) Directive and in compliance with local laws relating to this directive.
For more information on the WEEE Directive please visit
www.fellowesinternational.com/WEEE
Declaration of Conformity
Fellowes Manufacturing Company
Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England
declares that the product Model P-35C conforms with the requirements of the
Restriction of Hazardous Substances Directive (2002/95/EC), the Low Voltage
Directive (2006/95/EC) and the Electromagnetic Compatibility Directive
(2004/108/EC) and the following harmonized European Names (EN/IEC Standards)
and IEC Standards.
Safety: EN60950-1:2006+A11:2009+ A1:2010 IEC60950-1:2005 (2nd Edition)+A1:2009
EMC Standard: EN55014-1:2006+A1:2009 EN55014-2:1997+A1:2001+A2:2008
EN61000-3-2:2006+A1:2009+A2:2009 EN61000-3-3:2008
Itasca, Illinois, USA
December 1, 2010
Customer Service and Support
www.fellowes.com
Help Line
Australia | +1-800-33-11-77 |
---|---|
Canada | +1-800-665-4339 |
Europe | 00-800-1810-1810 |
Mexico | +1-800-234-1185 |
United States | +1-800-955-0959 |
Fellowes
Australia | +61-3-8336-9700 | Japan | +81-(0)-3-5496-2401 |
---|---|---|---|
Benelux | +31-(0)-76-523-2090 | Korea | +82-(0)-2-3462-2884 |
Canada | +1-905-475-6320 | Malaysia |
+60-(0)-35122-1231
Deutschland| +49-(0)-5131-49770| Polska| +48-22-205-21-10
Espana/Portugal| +34-902-33-55-69| Singapore| +65-6221-3811
France| +33-(0)-1-78-64-91-00| United Kingdom| +44-(0)-1302-836836
Italia| +39-071-730041| United States|
+1-630-893-1600
1789 Norwood Avenue, Itasca, Illinois
60143-1095 ● USA ● 630-893-1600
www.fellowes.com
©2011 Fellowes, Inc.
Part No. 405567
https://manual-hub.com/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>