Fellowes AutoMax 100M Cut Shredder Instruction Manual

Fellowes AutoMax 100M Cut Shredder

PLEASE READ THESE INSTRUCTIONS BEFORE USE. DO NOT DISCARD: KEEP FOR FUTURE REFERENCE.

KEY FEATURES AND CONTROLS

A. Auto Feed Tray
B. Auto Feed Flap
C. Disconnect Power Switch
Ο 1. OFF
Ι 2. ON
D. Manual Feed Slot
E. Pull-Out Bin
F. Casters
G. Auto Feed Tray Extension
H. See Safety Instructions
I. Control Panel and LEDs

1.  Reverse
2. ON/OFF and Start (blue)/Bin Open
3. Remove Paper (red)
4. Bin Full (red)
5. Overheat (red)

CAPABILITIES

Will shred: Paper, plastic credit cards, staples and small paper clips
Manual Feed
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:

Micro-Cut ………………………………………………………..5/32 in. x 25/64 in. (4mm x 10mm)

Maximum

Sheets per pass (Auto Feed) …………………………………………………………………………… 100
Sheets per pass (Manual Feed) ………………………………………………………………………… 10
Cards per pass ………………………………………………………………………………………………… 1*
Paper entry width ………………………………………………………………………….8.7 in. (220mm)

• 8.5 in. x 11 in., 20lb., (75g) paper at 120V/60 Hz, 3.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 1,000 sheets; 15 credit cards.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

• Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.
• Keep foreign objects — gloves, jewelry, clothing, hair, etc. — away from shredder openings. If object enters top opening, switch to Reverse (  ) to back out object.
• DO NOT use aerosol products, petroleum based or aerosol lubricants on or near shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON SHREDDER. Vapors from propellants and petroleum based lubricants may combust causing serious injury.
• Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water.
• Moving parts: do not touch.
• This shredder has a Disconnect Power Switch (C) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (0) position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.
• FIRE HAZARD — Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.

BASIC SET UP

CASTER INSTALLATION

BASIC SHREDDING OPERATION

Continuous operation: up to 15 minutes maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 15 minutes will trigger 35-minute cool down period.

MANUAL FEED

1. Plug in and put disconnect power switch in ON (I) position

2. Feed paper/card straight into paper entry and release.

AUTO FEED

1. Plug in and put disconnect power switch in ON (I) position

2. Extend auto feed paper tray*

3. Add paper

4. Press start ( ) to begin shredding

ADVANCED PRODUCT FEATURES

• Silent Shred™ Technology Silent Shred™ shreds without noisy disruptions.

• Energy Saving Sleep Mode Feature shuts down the shredder after 2 minutes of inactivity.

• Auto Reverse Stops and reverses paper if a jam occurs.

SLEEP MODE OPERATION

• Feature shuts down the shredder after 2 minutes of inactivity

WHEN IN SLEEP MODE

To get out of sleep mode, or Insert paper press start ( )

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com

PRODUCT MAINTENANCE

OILING SHREDDER

All micro-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding, and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

1. Apply oil across entry

2. Press and hold Reverse ( ) for 2-3 seconds

Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

CLEANING AUTO-START INFRARED SENSORS

Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
( Note: the paper detection sensors is located in the center of the paper entry).

TO CLEAN THE SENSORS

Turn off ( O) and unplug shredded

Locate Auto-start infrared sensor

Dip cotton swab in rubbing alcohol

Using cotton swab, wipe away any contamination from the paper sensors

TROUBLESHOOTING

Overheat Indicator : When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This
indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.  Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
Bin Full: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 36053.
Bin Open: The shredder will not run if the bin is open. Close the bin to resume shredding.
 Remove Paper: When illuminated, set to reverse ( ) and remove paper. Reduce paper quantity to an  acceptable amount and refeed into paper entry.

LIMITED PRODUCT WARRANTY

Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 7 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer

 CUSTOMER SERVICE & SUPPORT

www.fellowes.com

United States : 1-800-955-0959
Canada: 1-800-665-4339
Mexico: 001-800-514-9057
1789 Norwood Avenue, Itasca, Illinois 60143 t 1-800-955-0959 t www.fellowes.com

© 2018 Fellowes, Inc. | Part #410862 Rev B

References

• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>