ezviz CS-C3U 1080p Weatherproof Bullet POE Security Camera Installation Guide
- June 17, 2024
- ezviz
Table of Contents
CS -C3U
IP Camera
Installation Guide
Camera Overview
Installation Preparation
-
Make sure that the device in the package is in good condition and all the assembly parts are included.
-
Make sure that all the related equipment is powered off during the installation.
-
Make sure the wall is strong enough to withstand three times the weight of the camera and the mounting.
-
If the wall is cement, you need to insert expansion screws before you install the camera.
If the wall is wooden, you can use self-tapping screws to secure the camera. -
If the product does not function properly, please contact us at 1-855-MYEZVIZ (693-9849) or email us at service@ezvizlife.com.
-
Do not disassemble the camera for repair or maintenance by yourself.
Installation
-
Place the drill template sticker on the surface where the camera will be mounted.
-
Drill the screw holes according to the drill template, see figure 3-1.
-
Route the camera cables through the mounting base and wire the cables through the side opening.
-
Fix the mounting base to the ceiling or wall with PA4×25 screws (supplied), see figure 3-2.
-
Adjust the surveillance angle, see figure 3-3.
– Loosen the No. 3 adjusting screw to adjust the panning position (0° to 360°).
– Tighten the No. 3 screw after adjusting.
– Loosen the No. 2 adjusting screw to adjust the tilting position (0° to 90°).
– Tighten the No. 2 screw after adjusting.
– Loosen the No. 1 adjusting screw to adjust the azimuth angle of the image (0° to 360°).
– Tighten the No. 1 screw after adjusting. -
Connect the camera cables and finish installation.
UD.6L0208A0025A01
https://manual-hub.com/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>