FURUNO OP03-266 RP Chassis Installation Guide
- June 17, 2024
- FURUNO
Table of Contents
OP03-266 RP Chassis
Installation Guide
OP03-266 RP Chassis
For OP03-266
RP INSTALLATION GUIDE
This guide shows how to attach the RP chassis to the display unit RDP-161.
The RP chassis adds chart functionality to the FR-12.
For the details of the installation materials, see the packing list.
-
Open the rear cover of the display unit by removing five nuts, one ground terminal (M4×10) and eight binding head screws (M3×8) (positions are marked with dashed circles in the right figure).
-
Detach the lid (located where the RP chassis will be attached) from the inside of the rear cover by removing two binding head screws (M3×8). The lid can be discarded.
-
Place the RP chassis on the installation location marked with a dashed rectangle in the right figure.
-
Check that the stacking connector of the RP chassis is firmly connected to the circuit board of the display unit.
-
At the locations marked with dashed circles in the right figure, fasten the RP chassis to the display unit with four binding head screws (M3×6).
Tighten the two binding head screws which are located at the right side of the RP chassis first, then tighten the other two screws.
-
Attach the rear cover by reversing the order shown in step 1.
Note : Confirm that the panel gasket is correctly placed to the rear cover and attach the rear cover to the display unit. -
FOR JAPAN SPECIFICATION ONLY, attach the newpec JHA logo mark (supplied) next to the nameplate (right side when seen from the front of the display unit) at the top of the display unit.
FURUNO ELECTRIC co., LTD.
www.furuno.com
All brand and product names are trademarks, registered trademarks or service
marks of their respective holders.
| N A M E | O U T L I N E | DESCRIPTION/CODE № | Q’TY |
|---|
KIT PARTS
RP CHASSIS ASSEMBLY| | OP03-266-*
001-625-970-00
*| 1
NEWPEC STICKER| | NEWPEC| 1
(1)
BINDING HEAD SCREW| | M3X6 SWCH
000-176-673-10| 4
DOCUMENT
RP INSTALLATION GUIDE| | C32-02201-
000-199-587-1| 1
1.CODE NUMBER ENDING WITH INDICATES THE
CODE NUMBER OF REPRESENTATIVE MATERIAL.
2.(*1) MARKED PARTS ARE FOR JAPANESE SET ONLY.
DIMENSIONS IN DRAWING FOR REFERENCE ONLY.）
C3687-Z02-F CN
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>