ZHONGSHAN 2BD8V-001 2.4G Remote Control Instructions
- June 17, 2024
- Zhongshan
Table of Contents
ZHONGSHAN 2BD8V-001 2.4G Remote
Product Information
Specifications
- Input voltage: DC 3V
- Standby current: 3~10uA
- Controllable distance inside: 20m~60m
- RF band: 2.405GHz – 2.48GHz
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure conditions without restriction.
Product Usage
Remote Control Code
To set up the remote control code, follow these steps:
- Turn on the light.
- Within 5 seconds, press the SETUP key on the remote control.
- The light will flash or the buzzer will prompt, indicating that the code setup is successful.
Remote Control Clear Code
To clear the remote control code, follow these steps:
- Turn on the light.
- Keep the light on for 5 seconds.
- Press the total key on the remote control.
- The light will flash or the buzzer will prompt, indicating that the code clearing is successful.
FAQ
Q: What is the input voltage required for the product?
A: The input voltage required is DC 3V.
Q: What is the controllable distance of the remote control inside?
A: The controllable distance inside is 20m to 60m.
Q: Does the device comply with FCC regulations?
A: Yes, this device complies with part 15 of the FCC rules.
Directions for use
- Remote control code: Press the “SETUP” key within 5 seconds of turning on the light until the light flashes or the buzzer prompts, indicating that the code is successful.
- Remote control clear code: Turn on the light for 5 seconds to press the total key until the light flashes or the buzzer prompts, indicating that the code clearing is successful.
BUTTON FUNCTIONS
- Product parameters
- Input voltage: DC:3V
- Standby current: 3~10uA
- Controllable distance inside 20m~60m
- RF band: 2.405GHZ- -2.48GHZ
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>