LAZER Z1 Road Cycling Helmet Instruction Manual
- June 16, 2024
- LAZER
Table of Contents
LAZER Z1 Road Cycling Helmet
Product Information
Specifications
- Product Name: LifeBEAM Helmet Sensor
- Model: Z1, Blade, Wasp Air, Revolution
- Compatible Helmet Models: Wasp Air, Revolution
- Transmitter Case: Rubber
- Sensor Wire: Included
Product Usage Instructions
Installation of the Headband
- Turn the helmet over and remove the front foam pad.
- Install the LifeBEAM sensor pad in place of the foam pad.
- Depending on the size of the helmet, consider trimming the LifeBEAM sensor pad at the ends. Look for the trim line on each end of the pad and use standard scissors to cut the pad.
- Lay the sensor wire along the inside surface of the helmet.
- Consider using a small strip of tape to secure the wire in place.
- When the wire reaches the back of the helmet, thread the wire through the vent on the right side of the LifeBEAM MudCap.
- The sensor wire is now ready to be plugged into the transmitter.
How to Attach the Device to the Helmet
To attach the LifeBEAM transmitter to the helmet:
- Use the rubber slots on the transmitter case.
- Hook the transmitter onto the LifeBEAM MudCap.
- Assure that the transmitter is attached securely.
- Plug in the sensor wire.
Frequently Asked Questions (FAQ)
Q: Which helmet models are compatible with the LifeBEAM Helmet Sensor?
A: The LifeBEAM Helmet Sensor is compatible with the Wasp Air and
Revolution helmet models.
Q: Can I trim the LifeBEAM sensor pad to fit my helmet?
A: Yes, depending on the size of your helmet, you may consider trimming the
LifeBEAM sensor pad at the ends. Look for the trim line on each end of the pad
and use standard scissors to cut the pad.
Q: How do I secure the sensor wire inside the helmet?
A: You can lay the sensor wire along the inside surface of the helmet and
consider using a small strip of tape to secure the wire in place.
Q: Where should I thread the wire through the helmet?
A: When the wire reaches the back of the helmet, thread it through the vent
on the right side of the LifeBEAM MudCap.
Q: How do I attach the LifeBEAM transmitter to the helmet?
A: Use the rubber slots on the transmitter case to hook the transmitter
onto the LifeBEAM MudCap. Assure that the transmitter is attached securely.
Installation of the headband
Turn the helmet over and remove the front foam pad. Install the LifeBEAM sensor pad in place of the foam pad. Depending upon the size of the helmet you may consider trimming the Life-BEAM sensor pad at the ends. Look for the trim line on each end of the pad and use standard scissors to cut the pad. Lay the sensor wire along the inside surface of the helmet. You may consider using a small strip of tape to secure the wire in place. When the wire reaches the back of the helmet thread the wire through the vent on the right side of the LifeBEAM MudCap. The sensor wire is now ready to be plugged into the transmitter.
How to attach the device onto the helmet?
To attach the LifeBEAM transmitter to the helmet use the rubber slots on the
transmitter case and hook the transmitter onto the LifeBEAM MudCap. Assure the
transmitter is attached securely. Then plug in the sensor wire. 
Installation of the device
Z1
Blade
Wasp Air
Revolution
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>