White Rodgers 1E65-144 Non Programmable Electronic Digital Thermostat Instruction Manual

June 16, 2024
WHITE RODGERS

White Rodgers 1E65-144 Non Programmable Electronic Digital Thermostat Instruction Manual

White Rodgers 1E65-144 Non Programmable Electronic Digital Thermostat
Instruction Manual

DESCRIPTION

The 1E65-144 thermostat has been designed to control electric heating systems such as baseboard heaters, radiant floors, radiant ceilings and convectors.

The adapter plate is used to offset the thermostat when an obstruction prevents the thermostat from being mounted directly to the junction box.
The thermostat cannot be used with the following:
– a resistive load under 2 A
– a resistive load over 16.7 A
– systems driven by a contactor or a relay (inductive load)
– central heating systems
Parts Supplied: One (1) thermostat Two (2) 6-32 pan head screws
Available Accessories: F61-2642 Adapter Plate

White Rodgers 1E65-144 Non Programmable Electronic Digital Thermostat
Instruction Manual - DESCRIPTION

SPECIFICATIONS

White Rodgers 1E65-144 Non Programmable Electronic Digital Thermostat
Instruction Manual - SPECIFICATIONS

PRECAUTIONS

⚠  WARNING

  • Failure to read and follow all instructions carefully before installing or operating this control could cause personal injury and/or property damage.
  • All wiring must conform to local and national electrical codes and ordinances.
  • To prevent electrical shock, personal injury, and/or equipment damage, disconnect electric power to system at main fuse or circuit breaker box prior to installation or service.

INSTALLATION

Installation should be done by a qualified heating and air conditioning contractor or licensed electrician.
Loosen the screw holding the thermostat cover to the base, open cover on hinge and remove the cover.White Rodgers 1E65-144 Non Programmable Electronic
Digital Thermostat Instruction Manual - Loosen the screw holding the
thermostat cover to the base

Optional: Use the adapter plate accessory if you need to offset the mounting holes on the junction box. Align and affix the wall plate to the electrical junction box using two 6-32 flat head screws included with the plate.

NOTE
Use with copper conductors only. Use wire connectors approved for 12 AWG only.

Make the appropriate connections to the thermostat as per diagram below. The wires are non-polarized so either wire can be connected to either terminal.

CAUTION
Keep the air vents of the thermostat clean and unobstructed at all times. Failure to do so can cause harm to your thermostat.

White Rodgers 1E65-144 Non Programmable Electronic Digital Thermostat
Instruction Manual - INSTALLATION

OPERATION

White Rodgers 1E65-144 Non Programmable Electronic Digital Thermostat
Instruction Manual - OPERATION White Rodgers
1E65-144 Non Programmable Electronic Digital Thermostat Instruction Manual -
OPERATION

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

WHITE RODGERS User Manuals

Related Manuals