SUNUV SUN9C Gel Nail Polish Curing Lamp User Manual

SUNUV SUN9C Gel Nail Polish Curing Lamp

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER
DANGER – To reduce the risk of electrocution:

1. Always unplug this appliance immediately after using.
2. Do not place or store appliance where it can fall or be pulled into a tub or sink.
3. Do not use while bathing.
4. Do not place in or drop into water or other liquid.
5. Do not reach for an appliance that has fallen into water. Unplug immediately.

WARNING – To reduce the risk of burns, electrocution, fire, or injury to persons:

1. An appliance should never be left unattended when plugged in.
2. Close supervision is necessary when the appliance is used by, on, or near children or invalids.
3. Use this appliance only for its intended use as described in this manual, Do not use attachments not recommended by the manufacturer.
4. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water.
5. Return the appliance to a service center for examination and repair.
6. Keep the cord away from heated surfaces. a Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like.
7. Never drop or insert any object into any opening.
8. Do not use outdoors or operate where aerosol (spray) products are being used.
9. WARNING : Do not expose the skin to UVLED lamp for more than 10 minutes.
10. Individuals can’t reuse in one day.
    SAVE THESE INSTRUCTIONS

SAFETY WARNING

1. Please read through this User Manual carefully and keep it properly.
2. Please make sure the input voltage meets the requirements of the product.
3. Keep away from water or high humidity.
4. Do not allow debris or any types of liquid into the product, or a malfunction may occur.
5. When timer doesn’t work, stop using the product.
6. A damaged adapter must be replaced to avoid risk. Please contact your dealer regarding this matter.
7. Please apply neutral detergent for cleansing purposes. Make sure it is turned off and unplugged.Do not use remover or other acidic detergent to wipe.
8. Do not keep the machine working continuously for over 600s, otherwise it may reduce its lifespan.
9. It is recommended that curing time for base gel and color gel should not exceed 60s, and that of top coat should not exceed 90s.
10. Do not use gels that are not compatible with the product.
11. Apply proper maintenance may extend the lifespan.
12. Not suitable for people who are sensitive to UV, under certain medication or who require special care.
13. When not in use, please unplug.

ITEM CHECKLIST

• Lamp
• Adaptor
• User Manual

PARTS INTRODUCTION

1. Infrared Sensor
2. Power Button (30s/60s Switch)
3. 30s Indicator
4. 60s Indicator
5. Port

PRODUCT INTRODUCTION

The UVLED lamp is designed for both professional manicurists and amateurs, to cure UV, builder and LED gels.

HOW TO USE

1. Connecting adapter to host first, then plug adapter into outlet.
2. Put your fingers under the lamp, and it triggers the infrared sensor to start the curing process. The default process lasts for 99s.
3. Press the power button for a 30s cure. Press again for 60s. Press the third time to turn off the lamp.

TECHINCAL PARAMETERS

1. 18 LED beads
2. Lamp input voltage: DC 24V/0.65A (Powered by an external adapter)
3. Adapter : Rated input 100-240Vac 50/60Hz 0.5A
4. Rated output : DC 24V/0.65A
5. Size : 210mm x 120mm x 80mm
6. Wave length : 365m+405nm
7. Working Temperature : -10~+40°C;
8. Working Humidity: 10%-90%RH
9. Storage Temperature : -20~+60°C;
10. Storage Humidity : 5%-95%RH
11. Working Atmosphere : 86~106kPa

WARNINGS

1. Please use proper gels that are compatible with the product.
2. This product is not suitable for children, pregnant women or skin cancer patients.
3. Reduce skin exposure to the UV light, and do not stare at the UV light.
4. Do not overuse the product. Avoid eye exposure to the UV lights to prevent retinal damage.
5. It is recommended that you wear sunscreen before the cure.
6. Do not take any medication that triggers UV allergy. When in doubt, please consult with your physician.
7. If any discomfort occurs (e.g. rashes, pain) after the cure, please seek
8. medical attention immediately.

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FAQs

What is the SUNUV SUN9C Gel Nail Polish Curing Lamp?

The SUNUV SUN9C Gel Nail Polish Curing Lamp is a portable UV LED nail lamp designed for curing and drying gel nail polish.

How does the SUNUV SUN9C Gel Nail Polish Curing Lamp work?

The SUNUV SUN9C uses UV LED technology to emit the necessary wavelengths of light to cure and harden gel nail polish, allowing it to dry quickly and effectively.

Is the SUNUV SUN9C suitable for both professional and home use?

Yes, the SUNUV SUN9C is designed for both professional nail salons and home users, providing salon-quality results.

Does the SUNUV SUN9C have a timer function?

Yes, it has a 30s and 60s timer setting for convenience.

What is the wattage of the SUNUV SUN9C Gel Nail Polish Curing Lamp?

The SUNUV SUN9C operates at 24 watts.

Is the SUNUV SUN9C suitable for both professional and home use?

Yes, the SUNUV SUN9C is designed for both professional nail salons and home users, providing salon-quality results.

Is the SUNUV SUN9C easy to clean and maintain?

Yes, it has a removable base tray that makes cleaning and maintaining the lamp a breeze.

Can the SUNUV SUN9C cure all types of gel nail polishes?

Yes, it is compatible with all brands and types of gel nail polishes.

Does the SUNUV SUN9C have an auto-sensor for hands or feet?

Yes, it features an automatic sensor that activates the lamp when you place your hand or foot inside.

How long is the lifespan of the SUNUV SUN9C LED bulbs?

The LED bulbs have a long lifespan of up to 50,000 hours.

Is the SUNUV SUN9C portable and travel-friendly?

Yes, it's compact and lightweight, making it easy to transport and suitable for travel.

Can the SUNUV SUN9C be powered with a USB cable?

Yes, it can be powered through a USB cable, providing flexibility in usage.

What safety features are included with the SUNUV SUN9C?

The SUNUV SUN9C has overheat protection and a built-in timer to ensure safe and efficient curing without overheating or damaging your nails.

Video-SUNUV SUN9C Gel Nail Polish Curing Lamp

Download This Manual PDF:SUNUV SUN9C Gel Nail Polish Curing Lamp User Manual

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>