Tenda TEF1109P-8-63W 9 Port 10/100Mbps Desktop Switch with 8 Port PoE Installation Guide
- June 4, 2024
- Tenda
Table of Contents
Tenda TEF1109P-8-63W 9 Port 10/100Mbps Desktop Switch with 8 Port PoE
Package Contents
- Switch* 1
- Power Adapter “1
- Installation Guide• 1
If any item is incorrect, missing, or damaged, please keep the original package and contact the vendor for replacement immediately.
Product Overview
Application
Tip:
- All the ports support MDI/MDIX auto-negotiating .
- The PoE ports can dynamically provide suitable power to PoE devices.
LED Indicators
Ports/Switch/Interfaces
Tip:
- In Extend state, please use a CAT5E Ethemet cable or better, and make sure that the rale of the other device is set to Auto negotiation.
- In Default state, if you use a CAT5E Ethernet cable or better, lhe PoE data transmission distance is up to 14Dm.
Specifications
CE Mark Warning
This is a Class A product. In a domestic environment, this product may cause
radio Interference, in which case the user may be required to take adequate
measures. For Pluggable Equipment, the socket-outlet shall be installed near
the equipment and shall be easily accessible.
WARNING:
The mains plug is used as disconnect device, the disconnect device shall
remain readily operable.
cm Caution:
Adapter Model: BN031-A65051
Manufacture: SHENZHEN HEWEISHUN NETWORK TECHNOLOGY CO.,LTD.
Input: : 100-240V-, 50Hz/60Hz 1.5A
DC Voltage
Output: 51Vdc, 1.25A
RECYCLING
This product bears the selective sorting symbol for Waste electrical and
electronic equipment (WEEE). This means that this product must be handled
pursuant to European directive 2012119/EU in order to be recycled or
dismantled to minimize its impact on the environment. User has the choice to
give his product to a competent recycling organization or to the retailer when
he buys an new electrical or electronic equipment.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful Interference when
the equipment Is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense. This
device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
- this device may not cause harmful interference, and
- this device must accept any Interference received, including interference that may cause undesired operation.
Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE:
- The manufacturer is not responsible for any radio or TV Interference caused by unauthorized modifications to this equipment
- To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable.
Technical Support
United States Hotline: 1-800-570-5892
Canada Hotline: 1-888-998-8966
Hong Kong Hotline: 00852-81931998
Skype: Tendasz
Website: http:// www.tendacn.com
E-mail: support@tenda.com.cn
Address l11fo: 6-8 Floor, Tower E3, NO.1001, Zhongshanyuan Reed, Nanshan
District, Shenzhen, China. 518052
Copyright
e.2D18 Shenzhen Tenda Technology Co., Ltd. All rights reserved.
Tenda is a registered trademark legally held by Shenzhen Tenda Technology Co.,
Ltd. other brand and product names mentioned herein are trademarks or
registered trademarks of their respective holders. Specifications are subject
to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>