Cascadia T0681 Dunbar 1 Light Matte Black and Gold Contemporary Outdoor Wall Sconce Instruction Manual
- October 30, 2023
- Cascadia
Table of Contents
Cascadia T0681 Dunbar 1 Light Matte Black and Gold Contemporary Outdoor
Wall Sconce Instruction Manual
Hardware Package (included)
-
Crossbar Unit (A)
-
Mounting Screw (B)
-
Wire Connector (C)
-
Bolt Nut (D)
-
Rubber Pad (E)
Turn off the power at fuse or circuit box.
-
Attach the crossbar unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the preinstalled fixture mounting screws if necessary.
Note : Make sure that the fixture mounting screws are lined up horizontally to make the fixture level. -
Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
- Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
- Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
- Attach the fixture ground wire (bare wire) to the crossbar unit (A) with the green ground screw. Then, depending on local code, then connect it to the house ground wire with the wire connector (C). Carefully put all of the wires back into the outlet box.
-
Attach the backplate of the fixture to the crossbar unit (A) by inserting fixture mounting screws into open holes on the backplate, then secure it with two rubber pads (E) and two bolt nuts (D).
Note : With silicone caulk compound, caulk completely around where the backplate meets with the wall surface to prevent water from seeping into the outlet box. -
Attach the shade to the socket, then secure it with the socket ring.
-
Install the bulb (not included). Check relamping label at socket area or packaging for maximum wattage allowed.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
-
Crossbar Unit (A)
-
Mounting Screw (B)
-
Wire Connector (C)
-
Bolt Nut (D)
-
Rubber Pad (E)
