Platinium C 1308 Universal Charger Instruction Manual

Platinium C 1308 Universal Charger Instruction Manual

Warning: Please read this instruction manual carefully before using the instrument and keep it for future use.

SAFETY INSTRUCTIONS

1. The device is intended exclusively for private and not for commercial use. Only use this device as describe in this instruction manual.
2. Before to use, make sure that the supply voltage corresponds with the voltage marked on the rating label.
3. Do not place any part of this appliance in water or any other liquid.
4. Do not leave the device unattended when plugged in.
5. Unplug from the power outlet after use and allow the appliance to cool down completely before to clean it or to move it.
6. When disconnecting the cable, always pull at the plug; do not pull on the cable itself.
7. When using the device, always pull the power cord completely from its housing to prevent overheating.
8. If the cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid an electric shock.
9. Never try to repair it by yourself. It must be repaired by the manufacturer or its service agent or a similarly qualified person in order to avoid an electric shock.
10. The power cable must be checked regularly to avoid damage. If the power cable is damaged it must be replaced by a qualified service center to avoid any danger.
11. Always place your device on a dry surface.
12. Do not use outdoors.
13. Do not let the power cord on the edge of a table or work surface, and prevent it comes into contact with hot surfaces.
14. Keep it away from heat sources such as radiators, to avoid deformation of plastic parts.
15. Do not use coarse or abrasive sponges/cloths or steel wool to clean the appliance.
16. This unit is not designed to be operated by means of an external timer or a separate remote control system.

WARNING

• This charger is designed for standard / rechargeable alkaline batteries and rechargeable NiMH and NiCd batteries only.
• Always use well-known brand batteries of good quality and recently bought.
• Make sure that the batteries are correctly inserted into the battery compartments and that the polarity is correct.
• Never attempt to charge old, damaged or corroded batteries.
• Use only at room temperature of 0-40 ° Celsius. Avoid excessive heat and humidity.

INTRODUCTION

1. – pole
2. Battery compartment
3. + pole
4. LED light for 9V battery
5. LED light for other battery compartments
6. USB 1A
7. Battery selection switch
8. USB 2A
9. LCD screen
10. Power LED light
11. DC socket
12. 9V battery compartment

DESCRIPTION OF THE BATTERY CHARGER

This charger can charge 4 kinds of batteries Ni-CdNi-MH, RAM &Alkaline. Accommodates both AA, AAA, C, D size and 9V batteries.
The Four separate battery charging bays function independently
This enables charging of up to 4 batteries simultaneously.
Note: Batteries must of the same type is Ni-Cd、Ni-MH or alkaline.
Battery type is preselected therefore only one type (Ni-Cd, Ni-MH, RAM or alkaline (Ram Setting)) battery can be charged at one time.
This charger uses the latest battery charging technology. It uses “-delta V” deletion when charging Ni-Cd &Ni MH battery first, followed by a quick charge. Once the battery is fully charged, a constant current trickle charge will keep the battery at optimum capacity.
As 2 USB port to recharge smartphone and tablets.
Discharging Ni-Cd only: Discharge times will very dependant on capacity and charge state, typically the process could take up to one hour, before the charge cycle commences.
During the discharge process The indicator LED will glow amber.

IMPORTANT NOTE REGARDING THE RECHARGING OF ALKALINE BATTERIES:
This charger can charge and extend the life of most new and high quality alkaline batteries. Be sure to set the switch (7) to
“ALK” (leftmost position when facing the charger).
Most high-quality alkaline batteries can be recharged up to ten times, allowing them to hold about 75 to 90% of their power, until the batteries run out. These batteries should not be completely drained before recharging. For safe and optimal performance, please follow the instructions in this manual.

HOW TO USE IT

• Connect the DC plug from the AC adaptor to the DC socket on the rear of the charger.

• Insert the AC adaptor into the household supply ensuring the wall socket is switched ON. This will cause the LED power indicator light (10) to turn on.

• Select the required battery type by moving the selection switch (7) between Ni-Cd ,Ni-MH or ALK batteries (Switch must not be moved after batteries are loaded).

• Insert the required number of batteries into the charger, making sure the correct polarity is observed (+ is uppermost)

• After approximately 2 seconds the Charger will automatically detect the status of the battery.

• Once battery detection is complete one of the following charging programs will start.

• The charger automatically begins to charge your batteries, as indicated by both LED and LCD Status Indicators.
  

  • For NiCd batteries must first be discharged. The charger knows this and automatically discharges your NiCd batteries before charging to ensure ideal battery performance.
    Discharge is indicated by “DIS” appearing in the LCD Status Indicator. Once discharge has been completed, the unit will begin to recharge your NiCd batteries.

  • Ni-MH batteries have no memory effect. The charger will automatically start charging (the display will show “CHA” for “charging”). The battery icon will be displayed on the screen. When the battery is fully charged, the display shows the word “OK”. The icon of the charged battery appears on the screen and the indicator turns green.

  • Alkaline batteries can be regenerated as long as they are not fully discharged.
    The charger will automatically start charging (the display will show “CHA” for “charging”). The battery icon will be displayed on the screen.
    When the battery is fully charged, the display shows the word “OK”. The icon of the charged battery appears on the screen and the indicator turns green.

  • The 9V battery bay does not have a corresponding readout on the LCD display. The red 9V LED light indicates that the battery is being charged.
    When the light goes out the battery is fully charged.

  • Use the 1A USB port to charge smartphones and the 2A USB port to charge tablets.

  • When the battery are fully charged, it’s not necessary to remove them immediately as the charger will automatically keep it at its optimum capacity.

Attention if you are in Ni-Cd mode on the switch (7) but you put Ni-MH type batteries, the batteries can be discharged!

LCD and LED Display:

Battery
TYPE| Function
Discharge| LED Status
Indicator| LCD Status
Indicator| LCD Battery
Capacity Indicator
---|---|---|---|---
Ni-Cd| Yellow| DIS| Blinking DownwardFlashing Upward
Charging| Red| CHA
Fully Charged| Green| OK| Fully Charged
Ni-MH| Charging| Red| CHA| Flashing Upward
Fully Charged| Green| OK| Fully Charged
Alkaline| Charging| Red| CHA| Flashing Upward
Fully Charged| Green| OK| Fully Charged
Ni•Cd
Ni-MH
Alkaline| Battery Voltage is
Very Low—Battery
Can’t Recharge| Off| BAD|

CHARGING TIME

The approximate charge times is as follow depending on the brand and quality of the battery:

7,2Hours
Ni-MH| AAA AA C D| 800mAh 2300mAh 3300mAh 5000mAh| 1,3Hours 3,8Hours 5,4Hours 8Hours
Alkaline| AAA AA C D| 1.5V <1.4V 1.5V ><1.4V 1.5V ><1.4V 1.5V ><1.4V| About 2 to 5 hours
9V block| | 200mAh| 7 Hours

It is normal for batteries to get warm during the recharging process, please handle recharged batteries with care.

CARE AND MAINTENANCE

Clean the product only with a dry or slightly damp, lint-free cloth.
Do not use abrasive cleaners to clean the unit.

FEATURES

Material: ABS
Power supply: 100-240V / 12V power supply (adapter included),

The European directive 2012/19/EC about electronic and electric waste, requires that you can’t throw away defective domestic appliance with common waste. Used device has to be collect separately to optimize the recuperation rate and the recycling of the materials to reduce the impact on the health and the environment.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or by persons lacking in experience or knowledge, unless they are supervised or instructed on the use of this apparatus by a person responsible for their safety.Children should be supervised to ensure they do not play with this appliance.

Precision and precautions about the battery use

• Throwing away a used battery in the environment or with household waste pollutes and avoids the recuperation of reusable materials.
• It is important to limit the battery consumption and to respect the following rules:
  • Favor alkaline battery (last longer than saline battery) and when it’s possible use rechargeable battery.
  • Leave used batteries and accumulators in adapted containers that you can find in some retailers. In that way, metals don’t pollute the environment and the health.
• Battery has to be inserted by respecting the polarity show on the apparel and the battery. An incorrect positioning can damage the apparel, cause leaking and even provoke fire and the explosion of the battery.
• To assure a good functioning, battery has to be in a good condition. If there is a problem, put new battery.
• Never try to recharge battery not made for this. It could leak, warm up, cause fire or explode.
• Replace all the battery at the same time. Never mix up alkaline battery with saline battery.
• Used battery has to be removed.
• Also, remove the battery if you’re not using the apparel for a long time.
• Never try to short-circuit the terminal of a battery.
• Never throw away the battery in fire because they can explode.
• Take out the accumulator from the apparel before reload it.
• We recommend that an adult watch if a child change the battery to respect those rules.
• If you swallow a battery, go immediately to your doctor or the hospital.
• For the best ongoing performance, we recommend using only fresh, high-quality, alkaline batteries.

Importé par / Importiert von / Geïmporteerd door / Imported by / Importert av: CAPTELEC, 59170 Croix -FRANCE

Documents / Resources

| Platinium C 1308 Universal Charger [pdf] Instruction Manual
C 1308, C 0889, BW-E160010, C 1308 Universal Charger, Universal Charger, Charger
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>