AutoSky NCPAA Wireless CP and AA Adaptor User Manual
- June 16, 2024
- AutoSky
Table of Contents
Wireless CP &AA adaptor
SMART CONNECT – NANO SERIES
The key to wireless
User Manual
NCPAA Wireless CP and AA Adaptor
Model: CPAAC-1
FCC ID: 2A6P9-NCPAA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Product function introduction
Wireless transmission brings a more convenient connection experience and greatly enhances the owner’s experience of using CarPlay.
Output Resolution: Adaptative
Product specification parameters
Product Power: 0.15W
Power input: SV 1~2.lA
Compatibility
Your car must have Wired CarPlay (typically in cars 2016 or newer). Search for
compatible car models:
https://www.apple.com/ios/carplay/lavailable-models/
This adapter does not add CarPlay to your car, it only converts Wired CarPlay
to Wireless.
You need an iPhone 6 or newer with iOS 10 or later software version.
Product connection
- Connect your CPAA Adapter to your car’s USB port.
- Turn on your I phone or Android Phone’s Bluetooth, depending on the case, and select: “AutoSys-XXXX”. Allow pairing, syncing, and choose the use of CarPlay or Android Auto as appropriate.
- Select CarPlay or Android Auto according to your mobile phone brand, your adapter will recognize your device from your bluetooth connection.
- Once the connection is successful your CarPlay or Android Auto interface will be displayed on your screen and it will automatically reconnect each time.
Version update description
Connect your Wireless CPAA Adapter to a mobile phone charger as shown below.
Scan the QR Code with your camera or enter 192.168.3.l in Safari to update the firmware. This action is not recommended if your adapter is working properly.
Once you plug In your adapter connect It through your WiFi using the password:
8888888
Note: You need an I Phone and open mobile data function to update the
firmware.
Troubleshooting?
Scan this QR code in order to help you.
https://promasterelectronic.com/en/troubleshooting.html
customerservice@promasterelectronic.com
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>