APEVIA X-sniper2-gn ATX Mid Tower Gaming Case User Manual
- June 16, 2024
- APEVIA
Table of Contents
INSPIRE
USER’S MANUAL
Case Features
Case Specifications
Clearance:
Motherboard Support: ATX/Micro-ATX/Mini-ITX
Maximum GPU length: 360mm
Maximum PSU length: 220mm
Maximum CPU cooler height: 165mm
Cable Routing-Behind Motherboard: 25mm
Case Dimensions(mm): 410(L)210(W)450(H)
Drive Bays: 2.5″°SSD2/3.5″HDD2
Expansion Slots: 7| A:Tempered Glass Side Panel
B:PSU Dust Filter
C:PCI-E Back Cover
D:Top Dust Filter
E: Right Side Panel
F: HDD Trays
G: Front panel
---|---
Accessory Kit Contents
Specifications
Removing the Side Panel
Full Hinge Tempered Glass
Open the tempered glass side window to install the motherboard.
The motherboard standoffs are already preinstalled for you.
Installing the Motherboard
Align the motherboard holes to the motherboard standoffs and secure with the motherboard screws.
Fan installation and setup
- RGB/ ARGB fans and RGB button connectors included are already preinstalled and setup for you.
- If you have a RGB motherboard and would like to sync colors with fans, connect 3PIN+5V header to RGB motherboard.
- You can switch between 300+ RGB playable modes using the RGB button located on the top panel. 4.1o access the ARGB motherboard sync mode, hold down the RGB button for 5 seconds to switch to ARGB motherboard sync mode or “RGB Light Off” mode if you do not have ARGB motherboard. Hold down the RGB button for 5 seconds again to switch back to RGB button function.
- On the back of the controller board there is an adhesive tape. You can peel the seal and stick the controller board to anywhere in the case you prefer.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>