PureLink DOF-T2.0 HDMI 2×1 Switch with Motore Up Down Scaling User Manual
- June 16, 2024
- PureLink
Table of Contents
DOF-T2.0
4K60 DisplayPort and USB 2.0 Fiber Extender System
USER MANUAL
PureLink™
220-10 State Route 208
Fair Lawn, NJ 07410 USA
Tel: +1.201.488.3232
Fax: +1.201.621.6118
E-mail: sales@purelinkav.com
For order support, please contact your local dealer.
For technical support, please contact us at
support@purelinkav.com.
DOF-T2.0 HDMI 2×1 Switch with Motore Up Down Scaling
Thank You for Purchasing This Product
For optimal performance and safety, please read these instructions
carefully before connecting, operating or adjusting this product. Please keep
this manual for future reference.
Surge Protection Device Recommended
This product contains sensitive electrical components that may be damaged by
electrical spikes, surges, electric shock, lightning strikes, etc. The use of
surge protection systems is highly recommended in order to protect and extend
the life of your equipment.
Introduction
The DOF T2.0 Tx/Rx is TAA compliant, offering a powerful solution for long- distance distribution of DisplayPort 4K/60 video, audio, and control signals over fiber. Ultra HD/4K, HDMI 2.0 (18G), embedded audio, RS-232, and bi- directional IR are all supported over distances up to 3,300 ft. using PureLink’s TOTALWIRE LC-terminated fiber optic cables. The pure fiber connection provides protection from electromagnetic interference (EMI), delivering lossless transport for optimal signal quality.
Product Features
- TAA Compliant
- Supports resolutions up to 4K@60Hz 4:4:4, HDR
- Supports distances up to 1.24 miles (2000 m.) over single-mode fiber
- Real-Time Auto-EDID Management
- 18Gbps bandwidth support
- Supports LPCM 7.1 audio, Dolby TrueHD, Dolby Atmos, DTS-HD Master Audio, DTS:X formats
- Bi-directional IR & RS-232 control
- Supports USB keyboard mouse
Package Contents
- 1 x DOF-T2.0 Transmitter
- 1 x DOF-T2.0 Receiver
- 2 x 10G SFP+ 1.24 miles (2000 m.) single-mode optical transceiver, installed in Transmitter and Receiver
- 2 x DC 5V 2Amp power adapter
- 1 x IR Emitter cable
- 1 x IR Receiver cable
Specifications
Connector Type/s (Tx)| Inputs: (1) DisplayPort Type A female
Outputs: (1) SFP 10G+ Fiber module
Control: (1) D89 female [RS-232], (2) 3.5mm Jack [IR Input/Output]
---|---
Connector Type/s (Rx)| Inputs: (1) SFP 10G+ Fiber module
Outputs: (1) DisplayPort Type A female
Control: (1) DI39 male [RS-232], (2) 3.5mm jack [IR Input/Output]
Resolutions| 4K@60Hz 4:4:4 18Gbps (6Gbps per color) 1080p@60Hz 16bit, 3D, HDR,
Dolby Vision
Compliance| DisplayPort 1.2
Audio Formats| LPCM 7.1 @192KHz, Dolby TrueHD, Dolby Atmos, DTS-HD Master
Audio, DTS:X
Transmission Distance| up to 1.24 miles (2000 m.) over single-mode fiber
RS-232 Data Rate| 115200 bps / Full Duplex
Power Consumption| Max 5 W
Power Supply| DC 5V 2A
Temperature| Operation: 14113 F (-10-45 C) Storage: -22-158 C (-313-70 C)
Relative Humidity| Up to 95%
Product Dimensions| 4.31″x4.51″x1.18″ (109.6 x 114.5 x 30mm)
Product Weight| 0.6 lb. (270g)
Operation
Installation
Please note: the working distance is subject to the type of Fiber Optic cable
used and the type of transceiver used. The product comes with 10G SFP+ 2LC
Single Mode Fiber modules which can provide up to 2000 meters of extension
when used with quality single mode fiber cabling.
Make sure to use crossover style 2LC <> 2LC fiber cable.
DOF-T2.0 Transmitter Panel View
DOF-T2.0 Receiver Panel View
LED Indicators
- When the Green LED is on = unit is getting power
- When the Blue LED is on = Fiber link between transmitter and receiver is connected
DisplayPort
Connecting a DisplayPort cable with a valid signal at the input of the
Transmitter will automatically establish the connection through to the
Receiver.
Other signal extensions
You can choose between IR, RS232, or USB as an additional signal extension in
parallel with the DisplayPort extension. Review the Dip Switch Settings below
for the relative dip switch values.
Dip Switch Settings
| Switch | Function |
|---|---|
| SW 1 | ON |
Mouse Extender Function
SW 2| OFF| ON| ON
SWITCH position 1 and 2 must be positioned as above instructed above:
IR: SW1 ON (down position) + SW2 OFF (up position)
RS232: SW1 OFF (up position) + SW2 ON (down position)
USB: SW1 ON (down position) + SW2 ON (down position)
RS232 **
**
DB9 (F)
RS232
Pin| Define
Pin 2| RX
Pin 3| TX
Pin 5| GND
DB9 (M)
RS232
Pin| Define
Pin 2| RX
Pin 3| TX
Pin 5| GND
Warranty
PureLink Three (3) Year Limited Warranty for HDTools™ Branded Products Only
Dtrovision, LLC. (hereinafter “PureLink”) warrants its HDTools™ and PureStream™ branded products (hereinafter “Product”) purchased directly from PureLink or Dealer shall be free from defects in workmanship and materials, under normal use and service, for a period of three (3) years on parts and three (3) years on labor. Any repaired or replaced equipment related to Product shall be covered only under the remaining portion of the warranty. This warranty has no relationship to and exists independently of any warranty offered by the Dealer. This warranty is a limited warranty and gives you specific legal rights. You may also have other rights which vary from state to state.
TERMS & CONDITIONS
PureLink shall repair or replace the Product if it develops a material fault
during the period of warranty, on condition that i) the Product has only been
subject to normal use in a domestic or commercial environment in a manner
consistent with its specification and functionality, ii) the Product has been
cared for reasonably and only subjected to reasonable wear and tear, iii) the
defect has not been caused by willful or negligent abuse or neglect, or any
accident or improper installation procedure, iv) the serial number of the
Product has not been altered or removed.
This warranty only applies to the original purchaser and shall be the exclusive remedy to the original purchaser. PureLink shall not be liable for any damage whatsoever caused by the Product or the failure of Product to perform, including incidental or consequential damages. PureLink shall not be liable for any claim made by a third party or made by the purchaser for a third party.
Except as expressly set forth in this warranty, PureLink makes no other warranties, expressed or implied, including any implied warranties of merchantability and fitness for a particular purpose. PureLink expressly disclaims all warranties not satisfied in this limited warranty. Any implied warranties that may be imposed by law are limited to the terms of this limited warranty. This warranty statement supersedes all previous warranties.
WARRANTY RETURNS/REPAIRS/EXCHANGES
No merchandise may be returned without prior authorization from PureLink, and
a Return Materials Authorization (RMA) number.
Failure to comply with these conditions will result in rejection of the
returned merchandise.
Any warranty service on Products must be arranged through the Dealer.
Authorized returns must be shipped freight prepaid and fully insured to
PureLink, Ramsey, NJ USA, with the RMA number clearly marked on the outside of
all shipping boxes and containers. PureLink reserves the right at its sole
discretion to refuse any shipments arriving freight collect or without an RMA
number. Any authorized returned merchandise must be accompanied by a note
describing the reason for return, along with contact information including
name, phone number, return mailing and shipping addresses, e-mail address, and
RMA number.
On any products returned and accepted with an RMA number, return freight
charges following repair of items under warranty shall be paid by PureLink,
shipping by the standard ground carrier of its choice.
ADVANCE WARRANTY REPLACEMENTS
PureLink’s advance replacement service offers a Replacement Unit upon request
– free of charge for eligible products purchased less than one (1) year of the
warranty claim. Products purchased more than one (1) year prior to the
warranty claim do not qualify for advanced replacement services.
Advance replacement requests must be validated by a member of PureLink’s
Technical Support Team. Replacement units may be new or refurbished and are
subject to availability. PureLink is responsible for shipping the Replacement
Unit to your designated location by standard ground service. All other
shipping methods will be the responsibility of the Dealer.
Original Unit Return – the Original Unit must be returned within thirty (30) calendar days of the return authorization date. Failure to return the Original Unit within this period will be subject to a minimum 15% re-stocking fee. The dealer is solely responsible for the shipping of the Original Unit to PureLink.
TO MAKE A WARRANTY CLAIM
To make a warranty claim, promptly notify PureLink within the warranty periods
described above by calling PureLink’s Technical Support Department at
1-201-488-3232. PureLink, in its sole
discretion, will determine what action, if any, is required under this
warranty.
Most problems can be corrected over the phone through close cooperation
between Customer and a PureLink technician. To better enable PureLink to
address a warranty claim, please have the Product’s serial and model numbers.
If PureLink, in its sole discretion, determines that an on-site visit or
other remedial action is necessary, PureLink may send a representative to
Customer’s site.
Customer Service
Technical support inquiries can be submitted electronically through the PureLink website at www.purelinkav.com. For immediate assistance please contact PureLink’s Customer Care Team at +1 201-488-3232
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>