Safety 1ST TR405 Grow and Go Flex 8 in 1 Travel System User Guide

Grow and Go™
8-in-1 Stroller
Max 50 lb (22.7 kg)

Read all instructions BEFORE USING this product.
KEEP INSTRUCTIONS FOR FUTURE USE.
4358-8199B 09/13/22

Safety Information

WARNING:
FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE FOLLOWING WARNINGS AND ASSEMBLY INSTRUCTIONS AND KEEP FOR FUTURE REFERENCE.

• Adult assembly required.

• NEVER LEAVE CHILD UNATTENDED. ALWAYS keep child in view when in stroller.

• AVOID SERIOUS INJURY from falling or sliding out. ALWAYS use the harness system.
  Check frequently to make sure it is secure.

• ALWAYS keep fingers away from moving parts, when folding, unfolding or adjusting stroller to prevent finger entrapment.

• ALWAYS make sure stroller is FULLY OPEN AND LOCKED before using.

• ALWAYS use the brakes when stroller is stopped.

• ALWAYS remove protective material and poly bags and dispose before assembly.

• NEVER put hot liquids in the cup holder.

• Parent tray, including the cup holders, CANNOT exceed 3 lbs (1.4 kg) total.

• NEVER use stroller on stairs or escalators.

• NEVER rollerblade with stroller.

• NEVER allow children to play with or hang onto the stroller.

• NEVER allow children to climb into the stroller unassisted. Stroller may tip over and injure child.

• NEVER place or hang parcels, bags, or accessories on the handle or canopy. The stroller may tip over or the canopy may collapse.

• This product will become unstable if a parcel bag or rack is used when there is no provision for one.

• This product may become unstable if a parcel bag, other than the one recommended by the manufacturer is used.

• This product will become unstable if the manufacturer’s recommended load is exceeded.

• Care must be taken when folding and unfolding the stroller to prevent finger entrapment.

• Child may slip into leg openings and strangle, unless you disengage buckle under the foot rest and press down the foot area to create safe enclosure.

• DO NOT carry additional children, goods, or accessories in or on this product except as recommended in the manufacturer’s instructions.

• NEVER place more than 10 lb (4.5 kg) in the storage basket. If weight is exceeded, hazardous unstable conditions may exist.

• STROLLER is only for use with children up to 50 lb (22.7 kg), and WHEN SEATED, the midpoint of your child’s head is at or below the top of the stroller seat.

• ONLY use this stroller with ONE child at a time.

• STROLLER mode is for use with children who can sit up unassisted and is NOT recommended for newborns.

• Failure to follow the steps and warnings on the labels and in the instruction manual can result in serious injury or death to your child.

Parts of Stroller

Installing Wheels

Unfasten frame lock.

• Unfold the stroller until you hear it click and lock into fully the open position.
• Lay the stroller down on the floor as shown.

Attach the front swivel wheels as shown.

WARNING:
ALWAYS keep fingers away from moving parts, when folding, unfolding, or adjusting stroller to prevent finger entrapment.

• Align the rear wheel assembly hubs with the rear leg posts on the stroller frame.
• The pin on the stroller frame will go into the slot in the wheel assembly hubs as shown.
• Then set the stroller upright.

Finished!
NOTE: Pull down on the front wheels and rear wheel assembly to make sure they are attached securely.
To use parking brake, see page 4.
For Car Seat Carrier Mode, see page 6.
For Stroller Seat Mode, see page 7.
For Carriage Mode, see page 8.
For Travel System Mode, see page 9.
To fold and unfold stroller, see pages 20-21.

Using Parking Brake

Removing Wheels

Rear Wheel Assemby

Turn stroller upside down.
Locate the rear wheel release buttons.

Press the release buttons while pulling the rear wheel assembly up and pull it away from the stroller.

Front Swivel Wheels

Locate the front wheel release button.
Press the release button in while pulling the front wheel down.
Repeat for other side.

Modes of Use

Car Seat Carrier Mode

Car seat can be used rear-facing or forward-facing.
See car seat instruction manual for how to secure your child in the car seat.

Example shown of an onBoard Model’s Stroller Release Handle

Car seat stroller release mechanisms & locations vary by car seat model.
Review your car seat’s instruction manual to locate the stroller release mechanism on your car seat.

Illustrations show a generic car seat icon.

While engaging your car seat’s stroller release mechanism, lift the car seat off of the stroller frame.

Stroller Seat Mode

Stroller seat can be used rear-facing or forward-facing.

Attach the stroller seat rear-facing or forward-facing to the attachments on the stroller frame.

Finished!
To adjust the stroller seat backrest, see page 10.
To adjust positions of the stroller seat, see page 11.
To secure child in stroller seat, see page 16.

Removing Stroller Seat from Stroller Frame

Press the release buttons on each side of the seat all the way in and  lift the stroller seat up and off of the stroller frame.

Carriage Mode

Carriage mode can be used rear-facing or forward-facing.

Attach the stroller seat either rear-facing or forward-facing to the attachments on the stroller frame.
Fully recline the stroller seat backrest.
At the back of the stroller seat, press the button on the backrest adjuster all the way and pull it towards you.
For more information about adjusting the backrest, see page 10.
Push the seat stroller adjustment buttons and rotate the seat all the way back.
For more information about stroller seat positions, see page 11.

Locate the strap under the footrest.
Undo the buckle on the strap as shown.

WARNING:
Child may slip into leg openings and strangle, unless you disengage buckle under the foot rest and press down the foot area to create safe enclosure.

Travel System Mode

Stroller seat can be installed rear-facing or forward-facing.
Car seat MUST ALWAYS face the stroller seat when in travel system mode.
Child tray MUST ALWAYS be used in travel system mode.

Install the stroller seat
either rear-facing or
forward-facng to the
attachments on the
stroller frame. You will
hear each side“click”
when it is locked
into place.| Fully recline the
stroller seat backrest.
For more information
about adjusting
the backrest,
see page 10.| Fold the canopy back.
Adjust the stroller seat to the
most upright position.
For more information about
stroller seat positions,
see page 11.| Attach the child tray.
For more information
about the child tray,
see page 14.d

Install the car seat to the
attachments on the stroller seat. You  will hear each side “click” when it is secure.| Pull the car seat up either at
the carry handle or handle hubs to check if it  is attached  securely.| Finished!
To remove carseat from stroller seat, see page 6: Removing Car Seat from Stroller Frame or  Stroller Seat.

Adjusting Stroller Seat Backrest

At the back of the stroller seat, slide and hold the button on the backrest adjuster and pull the adjuster away from the seat.

To Make Backrest Upright

At the back of the stroller seat, hold the loose end of the strap and slide the backrest adjuster up the strap toward the back of the seat.

Illustrations show the stroller seat backrest upright and reclined; however there are multiple recline positions.

Adjusting Stroller Seat Positions

Attaching & Removing Canopy

Align the canopy tabs with the attachment on the stroller frame and push the canopy tabs down to snap them to the stroller frame.

To Remove Canopy

Locate the canopy tabs and pull them forward to remove the canopy from the stroller frame.

Adjusting Canopy

Pull the canopy forward.
On select models: Unzip the canopy to extend it farther.

Lift the fabric to access the Peek-a-Boo window.

Adjusting Footrest

To lower footrest, press the footrest adjustment buttons and push down on the footrest.

To raise footrest, pull the footrest up until it locks into place.

Attaching & Removing Child Tray

To Attach Child Tray

Locate the child tray attachment hubs
on each side of the stroller frame.| Align the posts on the
child tray with the slots in
the attachment hubs.| Gently pull out on tray to
make sure it is attached
securely.d

The child tray can also swivel open to make it easier to put in or remove your child.

To Swivel Open

Locate one of the buttons underneath
each side of child tray.
Press one button and push the child tray
to the side of the stroller frame.| Locate the buttons underneath
each side of child tray.
Press both buttons and pull the child tray away
from the stroller frame.

Parent Tray & Storage Basket Use

WARNING:

• NEVER place more than 10 lb (4.5 kg) in the storage basket. If weight is exceeded, hazardous unstable conditions may exist.
• Parent tray, including the cup holders, CANNOT exceed 3 lbs (1.4 kg) total.

Securing Child in Stroller Seat

WARNING:

• NEVER LEAVE CHILD UNATTENDED. ALWAYS keep child in view when in stroller.
• AVOID SERIOUS INJURY from falling or sliding out. ALWAYS use the harness system. Check frequently to make sure it is secure.
• STROLLER is only for use with children up to 50 lb (22.7 kg), and WHEN SEATED, the midpoint of your child’s head is at or below the top of the stroller seat.
• ONLY use this stroller with ONE child at a time.
• STROLLER MODE is for use with children who can sit up unassisted and is NOT recommended for newborns.
• Failure to follow these instructions could result in serious injury or death of your child.

Wash & Care of Stroller Parts

Cleaning Harness Covers & Buckle Cover

• Machine wash separately with cold water on a gentle cycle.
• Do not use bleach.
• Tumble dry separately for 1012 minutes on low heat.
• Remove immediately.

Dorel Juvenile Group Information

Thank you for choosing this stroller.
The DJG family is committed to creating strollers with the most comfort and convenience available today.
If you have questions or any concerns with this stroller, please contact our Consumer Care Department.
For parts availability and questions, please contact us via phone, text, or chat.
Include the model number and manufacture date (found on a sticker on the stroller frame) and a brief description of the part.

• Rear Wheel Assembly
• Front Swivel Wheels (2)
• Harness Covers (2)
• Child Tray
• Buckle Cover

Call: 1-800-544-1108
Text: 1-812-652-2525
Chat: www.safety1st.com

Hours of Operation:
M-TH: 8:00 AM – 6:00 PM EST
FRI: 8:00 AM – 4:30 PM EST

Two-Year Limited Warranty

Dorel Juvenile Group, Inc. warrants to the original purchaser that this product (Grow and Go 8-in-1 Stroller), is free from material and workmanship defects when used under normal conditions for a period of two (2) years from the date  of purchase. Should the product contain defects in material or workmanship Dorel Juvenile Group, Inc., will repair or replace the product, at our option, free of charge. Purchaser will be responsible for all costs associated with packaging  and shipping the product to Dorel Juvenile Group Consumer Care Department at the address noted on the back of this document and all other freight or insurance costs associated with the return. Dorel Juvenile Group will bear the cost  of shipping the repaired or replaced product to the purchaser. Product should be returned in its original package accompanied by a proof of purchase, either a sales receipt or other proof that the product is within the warranty period. This  warranty is void if the owner repairs or modifies the product or the product has been damaged as a result of misuse. This warranty excludes any liability other than that expressly stated previously, including but not limited to, any incidental or inconsequential damages. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS THAT MAY VARY FROM STATE TO STATE.

References

• Safety 1st Baby Products | Baby Car Seats, High Chairs & More
• Safety1st Canada (English) Homepage

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>