Canshengda M33 Bluetooth Headset User Manual

Canshengda M33 Bluetooth Headset

Function definition

Key description

1. Power on: press and hold the function key for 2 seconds
   Power off: press and hold the function key for 5 seconds

2. Play/pause music: press once briefly Switch to the next song: short press 2 times Switch to the previous song: short press 3 times

3. Start the voice assistant: press and hold the function key for 1.5 seconds

4. Call Answer/Hang Up: Press once Reject the call: press and hold for 2 seconds 5.Switch Chinese/English mode: when not connected press it twice

Function introduction

1. [Connect Bluetooth] Tum on Bluetooth or other devices. Settings Bluetooth Search Bluetooth name, “OWS/OWS Pra/OMS-PLUS” Select the device, and click to connect it in pair
2. [music playback] open the mobile music player to play, press the function key to pause the playback, and than press the function key again to play the music
3. answer the phone]when the headset and mole phone are connected, press the function key to connect the phone, press the function key again to hang up, and press and hold for 2 seconds to refuse to answer and hang up the phone
4. [voice prompt] the machine has voice prompt Voice prompt: power on (prompt for power cm), power on(prompt for power on) pairing (prompt for pairing),connected (connected) disconnected (disconnected) and voice will report the phone number when calling
5. [charging] please use the standard charging line The charging red light is on When the battery is fully charged, the red light goes out and the blue light is always on

Technical Specification

Version:5.3
Supported Agreement: A2DPIHFPISPPIHID/PBAP Bluetooth Scope:≥10m
Frequency: 20Hz-2,000Hz Nesistance:320 Sensithty.108±3dB
Charging Specfication: DC5W/1A
Charging time: about 1 hour Operation Volage:3.3V-4.2V
Texture: AB

Warm reminder. If the indicator light is always on or crashes during the use of the headset, please press and hold the power button for8 seconds to reset and restart.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation

FCC STAYMENTS

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee Vthat interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment The devices has been evaluated to meet general RF exposure requirement, the device can be used in portable exposure condition without restriction

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>