Screwfix LAP BK7S-L90W LED Batten Instruction Manual

: June 16, 2024
: SCREWFIX

Table of Contents

Parts
You will need
Care & maintenance
Safety
Technical Data
Guarantee
Installation
Interconnection
Customer Support
Documents / Resources

Screwfix LAP BK7S-L90W LED Batten

Screwfix LAP BK7S-L90W LED Batten

IMPORTANT – These instructions are for your safety. Please read through them thoroughly prior to handling the product and retain them for future reference.

Parts

You will need

Care & maintenance

Safety

IMPORTANT Do not use with a dimmer switch.
IMPORTANT, Retain for future reference: read carefully.
These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference.
All fittings must be installed by a competent person in accordance with local regulations (IET wiring regulation BS7671).
Check the pack and make sure you have all of the parts listed.
Remove all packaging, wrap etc from the product.
Decide on the appropriate location for your product.
CAUTION: IP65 is guaranteed when the product is properly installed and sealed.
Always avoid the product to be located at corrosive environment.
Always refer to the installation drawing for the orientation of the product.
The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings not supplied and must be purchased.
Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation.
IMPORTANT: The fixing point(s) selected must be capable of supporting the full weight of the light fitting.
Wiring diagram is for reference only. Always refer to the terminal marking for wiring. Ensure that all electrical connections are tight and that no loose strands are left out of the terminal block.
Never put anything on the product or hang anything on any part of this product.
Never use the terminal cables to bear the product weight.
Non-replaceable control gear.
When the product does not light after installation:
- Ensure there is no electricity failure
- Ensure all the connections are secured
If you have any doubt about installation/use of this product, consult a qualified electrician.
Always disconnect the product from mains at least 10 minutes allowing to cool down before any maintenance or adjustment.
Non-replaceable control gear.
It is recommended to have a regular schedule of care and maintenance to keep the surface condition well.

Technical Data

Supply voltage:	220-240 V~, 50 Hz
Bulb type:	Model:

with same model:
BK7S-L90W| 5063022044167/ 5059340374703| 31W| 8pcs
BK7S-L120W| 5063022044174/ 5059340374697/ 5063022047342| 37W| 8pcs
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.

Do not stare at the operating light source.

Frequency range:| 5725Mhz-5875MHz
Transmitter power:| -24.32dBm
| This product complies with conformity requirements of the applicable European Regulations or Directives.
| This product complies with conformity requirements of the applicable UK Regulations.
Symbol | Class II product – Double Insulated – No earth required.
Energy efficiency class| This product contains a light source of energy efficiency class
| For indoor use only.
IP65| Splash-proof
| Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
| Do not use with a dimmer switch.
xxWyy:| xx-year; yy-week of the year.

Guarantee

We take special care to select high quality materials and use manufacturing techniques that allow us to create products incorporating design and durability. This product has a manufacturer’s guarantee of 5 years against manufacturing defects, from the date of purchase (if bought in store) or date of delivery (if bought online), at no additional cost for normal (non professional or commercial) household use.

To make a claim under this guarantee, you must present your proof of purchase (such as a sales receipt, purchase invoice or other evidence admissible under applicable law), please keep your proof of purchase in a safe place. For this guarantee to apply, the product you purchased must be new, it will not apply to second hand or display products. Unless stated otherwise by applicable law, any replacement product issued under this guarantee will only be guaranteed until expiry of the original period guarantee period.

This guarantee covers product failures and malfunctions provided the product was used for the purpose for which it is intended and subject to installation, cleaning, care and maintenance in accordance with the information contained in these terms and conditions, in the user manual and standard practice, provided that standard practice does not conflict with the user manual.

This guarantee does not cover defects and damage caused by normal wear and tear or damage that could be the result of improper use, faulty installation or assembly, neglect, accident, misuse, or modification of the product. Unless stated otherwise by applicable law, this guarantee will not cover, in any case, ancillary costs (shipping, movement, costs of uninstalling and reinstalling, labour etc), or direct and indirect damage.

If the product is defective, we will replace or refund, within a reasonable time.

Rights under this guarantee are enforceable in the country in which you purchased this product. Guarantee related queries should be addressed to the store you purchased this product from.

The guarantee is in addition to and does not affect your statutory rights.

(UK) DECLARATION OF CONFORMITY
DECLARATION OF CONFORMITY

Product

GALLIUS IP65 Batten Wide Link Microwave sensor

Name and address of the manufacturer or his authorised representative:
Kingfisher International: Kingfisher International Products B.V.,
Products Limited: Rapenburgerstraat 175E,
1 Paddington Square: 1011 VM Amsterdam,
LONDON W2 1GG United Kingdom: The Netherlands
This declaration of conformity is issued under the sole responsibility of the manufacturer.
Object of the declaration
Product| Model| EAN
GALLIUS IP65 90cm Batten Wide Link Microwave sensor| BK7S-L90W| 5063022044167
HECTORIA IP65 90cm Batten Wide Link Microwave sensor| BK7S-L90W| 5059340374703
GALLIUS IP65 120cm Batten Wide Link Microwave sensor| BK7S-L120W| 5063022044174
HECTORIA IP65 120cm Batten Wide Link Microwave sensor| BK7S-L120W| 5059340374697
GALLIUS IP65 120cm Batten Wide Link Microwave sensor| BK7S-L120W| 5063022047342
The object of the declaration described above is in conformity with the relevant legislation:
Radio Equipment Regulations 2017 as amended
The Restriction of the use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012 as amended
The Ecodesign for Energy-Related Products and Energy Information Regulations 2021
Electrical Equipment (Safety) Regulation 2016 as amended Electromagnetic Compatibility Regulations 2016 as amended
References to the relevant designated standards used or references to the other technical specifications in relation to which conformity is declared:
BS EN IEC 60598-1:2021/ EN IEC 60598-1:2021
BS EN IEC 60598-2-1:2021/ EN IEC 60598-2-1:2021 BS EN 62479 :2010/ EN 62479 :2010
BS EN 50663:2017/ EN 50663:2017
ETSI EN 300 440 V2.2.1/ EN 300 440 V2.2.1 ETSI EN 301489-1 V2.2.3/ EN 301489-1 V2.2.3 ETSI EN 301489-3 V2.1.1/ EN 301489-3 V2.1.1
BS EN IEC 55015:2019+A11:2020/ EN IEC 55015:2019+A11:2020 BS EN 61547:2009/ EN 61547:2009
BS EN IEC 61000-3-2:2019+A1:2021/ EN IEC 61000-3-2:2019+A1:2021
BS EN 61000-3-3:2013+A2:2021/ EN 61000-3-3:2013+A1:2017+A2:2021
Where applicable, the approved body Bureau Veritas Consumer Products Services, Inc. (AB2200) performed Radio Equipment Directive and issued the certificate: CS35116
Signed for and on behalf of:

Kingfisher International: Kingfisher International Products B.V.,
Products Limited: Rapenburgerstraat 175E,
1 Paddington Square: 1011 VM Amsterdam, LONDON W2 1GG United Kingdom The Netherlands

David Awe

Group Quality Director

EU DECLARATION OF CONFORMITY| | BS EN IEC 60598-1:2021/ EN IEC 60598-1:2021
BS EN IEC 60598-2-1:2021/ EN IEC 60598-2-1:2021 BS EN 62479 :2010/ EN 62479 :2010
BS EN 50663:2017/ EN 50663:2017
ETSI EN 300 440 V2.2.1/ EN 300 440 V2.2.1 ETSI EN 301489-1 V2.2.3/ EN 301489-1 V2.2.3 ETSI EN 301489-3 V2.1.1/ EN 301489-3 V2.1.1
BS EN IEC 55015:2019+A11:2020/ EN IEC 55015:2019+A11:2020 BS EN 61547:2009/ EN 61547:2009
BS EN IEC 61000-3-2:2019+A1:2021/ EN IEC 61000-3-2:2019+A1:2021
BS EN 61000-3-3:2013+A2:2021/ EN 61000-3-3:2013+A1:2017+A2:2021|
---|---|---|---
Product|

GALLIUS IP65 Batten Wide Link Microwave sensor

|
References to the relevant harmonised standards used or references to the other technical specifications in relation to which conformity is declared:|
Name and address of the manufacturer or his uthorized representative:|
Kingfisher International Products B.V., Rapenburgerstraat 175E, 1011 VM Amsterdam, The Netherlands|
This declaration of conformity is issued under the sole responsibility of the manufacturer.|
EN IEC 60598-1:2021
EN IEC 60598-2-1:2021
EN 50663:2017
EN 62479:2010
EN 300 440 V2.2.1
EN 301489-1 V2.2.3
EN 301489-3 V2.1.1
EN IEC 55015:2019+A11:2020 EN 61547:2009
EN IEC 61000-3-2:2019+A1:2021
EN 61000-3-3:2013+A1:2017+A2:2021|
Object of the declaration|
Product| Model| EAN|
GALLIUS IP65 90cm Batten Wide Link Micro-wave sensor| BK7S-L90W| 5063022044167|
HECTORIA IP65 90cm Batten Wide Link Micro-wave sensor| BK7S-L90W| 5059340374703|
Where applicable, the approved body Bureau Veritas Consumer Products Services, Inc. (AB2200) performed Radio Equipment Directive and issued the certificate: CS35115|
GALLIUS IP65 120cm Batten Wide Link Micro-wave sensor| BK7S-L120W| 5063022044174|
HECTORIA IP65 120cm Batten Wide Link Micro-wave sensor| BK7S-L120W| 5059340374697|
GALLIUS IP65 120cm Batten Wide Link Micro-wave sensor| BK7S-L120W| 5063022047342|
The object of the declaration described above is in conformity with the relevant Union harmonisation legislation:|
Signed for and on behalf of/Signé par et au nom de/Podpisano w imieniu/ Semnat pentru și în numele/Firmado en nombre de/Assinado por e em nome de:

Kingfisher International Products B.V., Rapenburgerstraat 175E,

1011 VM Amsterdam, The Netherlands

David Awe

Group Quality Director 04/11/2022

|
2014/53/EU as amended Radio Equipment Directive|
References to the relevant designated standards used or references to the other technical specifications in relation to which conformity is declared:|
|

Installation

IMPORTANT DO NOT USE WITH A DIMMER SWITCH.
IMPORTANT! RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.

Installation

EAN	L1

5063022044167
5059340374703| 300 mm
5063022044174
5059340374697
5063022047342| 400 mm

Installation

L = Brown or Red | N = Blue or Black

Installation

This light use microwave motion detection, it may detect occupants through doors, glass windows or thin walls. Above 2.5 m installation height, the sensor sensitivity may be reduced.

Interconnection

Model:| EAN:| Rated wattage:| Maximum number of interconnected with same model:
---|---|---|---
BK7S-L90W| 5063022044167/ 5059340374703| 31W| 8pcs
BK7S-L120W| 5063022044174/ 5059340374697/ 5063022047342| 37W| 8pcs