Screwfix SL06-2209-B Shipton Single 4ft LED Batten Instruction Manual

: June 16, 2024
: SCREWFIX

Table of Contents

Screwfix SL06-2209-B Shipton Single 4ft LED Batten
Product Information
Product Usage Instructions
OVERVIEW
Parts
You will need
Care & maintenance
Safety
Technical Data
Guarantee
Installation
Manufacturer
Documents / Resources

Screwfix SL06-2209-B Shipton Single 4ft LED Batten

Screwfix-SL06-2209-B-Shipton-Single-4ft-LED-Batten-
product

Product Information

Product Name: KNG-1752-0006
EAN: 5063022044235
Impala Ref: PRJ26507
Page Size: A3

Specifications

Supply Voltage: 220-240 V~, 50 Hz
Model: SL06-2209-B / SL06-2209-W / SL06-4218-B / SL06-4218-W
Rated Wattage: 18 W (LED) for SL06-2209-B / 36 W (LED) for SL06-4218-B
Bulb Type: LED
Energy Efficiency Class: [Class]
Product Class: Class I (must be connected to Earth)
Intended Use: Indoor use only
IP Rating: IP20 (protected against access with a finger)

Safety Instructions

Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.
Risk of electric shock! Ensure there is no electricity failure to keep the surface condition well.
Do not stare at the operating light source.
This product complies with the conformity requirements of the applicable European Regulations or Directives.
This product complies with the conformity requirements of the applicable UK Regulations.
Do not use it with a dimmer switch.

Product Usage Instructions

Installation

Make sure the power supply is switched off before installation.
Choose a suitable location for the product.
Mount the product securely using the provided mounting hardware.
If required, connect the product to the electrical supply following proper electrical wiring guidelines. If you are unsure, consult a qualified electrician.

Operation

Once the product is installed, switch on the power supply.
Use the provided controls or switches to turn on/off or adjust the lighting as desired.

Maintenance

To ensure the product’s optimal performance and longevity, follow these maintenance guidelines:

Regularly clean the product using a soft, dry cloth. Do not use abrasive cleaners or solvents.
Inspect the product for any signs of damage or wear. If any issues are found, contact the manufacturer or an authorized service agent for assistance.
Do not attempt to replace the light source yourself. Contact the manufacturer or a qualified person for replacement.

Guarantee

This product has a manufacturer’s guarantee of 5 years against manufacturing defects, from the date of purchase (if bought in-store) or date of delivery (if bought online), at no additional cost for normal (nonprofessional or commercial) household use.
Please refer to the guarantee terms and conditions for more details.

FAQ

Q: Can I use this product outdoors?

A: No, this product is intended for indoor use only.

Q: Can I use a dimmer switch with this product?

A: No, this product should not be used with a dimmer switch.

Q: How do I clean the product?

A: Use a soft, dry cloth to regularly clean the product. Do not use abrasive cleaners or solvents.

Q: Can I replace the light source myself?

A: No, the light source should only be replaced by the manufacturer or a qualified person.

Q: What should I do if I experience any issues with the product?

A: If you experience any issues with the product, such as defects or malfunctions, please contact the manufacturer or an authorized service agent for assistance.

OVERVIEW

LED Batten

SL06-2209-B
- 5063022044235
- 5063022044242
SL06-4218-B
- 5063022044259
- 5063022044266
SL06-2209-W
- 5063022044273
SL06-4218-W
- 5063022044280
- 5063022047366

Parts

You will need

Care & maintenance

Screwfix-SL06-2209-B-Shipton-Single-4ft-LED-Batten-
fig-4

Safety

IMPORTANT Do not use with a dimmer switch.
IMPORTANT, Retain for future reference: read carefully.
These instructions are for your safety. Please read through them thoroughly before installation and retain them for future reference.
All fittings must be installed by a competent person according to local regulations (IET wiring regulation BS7671).
Check the pack and make sure you have all of the parts listed.
Remove all packaging, wrap, etc from the product.
Decide on the appropriate location for your product.
This product is suitable for indoor use only and not for areas constantly subject to moisture such as bathrooms.
Always refer to the installation drawing for the orientation of the product.
The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings are not supplied and must be purchased.
Take care not to drill into any pipes or main cables beneath the surface during mounting hole preparation.
IMPORTANT: The fixing point(s) selected must be capable of supporting the full weight of the light fitting.
A wiring diagram is for reference only. Always refer to the terminal marking for wiring. Ensure that all electrical connections are tight and that no loose strands are left out of the terminal block.
Never put anything on the product or hang anything on any part of this product.
Never use the terminal cables to bear the product weight.
Non-replaceable control gear.
When the product does not light after installation:
Ensure there is no electricity failure
Ensure all the connections are secured
If you have any doubt about the installation/use of this product, consult a qualified electrician.
Always disconnect the product from the mains for at least 10 minutes allowing it to cool down before any maintenance or adjustment.
It is recommended to have a regular schedule of care and maintenance to keep the surface condition well.

Technical Data

Screwfix-SL06-2209-B-Shipton-Single-4ft-LED-Batten-
fig-6

Guarantee

We take special care to select high-quality materials and use manufacturing techniques that allow us to create products incorporating design and durability.
This product has a manufacturer’s guarantee of 5 years against manufacturing defects, from the date of purchase (if bought in-store) or date of delivery (if bought online), at no additional cost for normal (nonprofessional or commercial) household use.
To claim this guarantee, you must present your proof of purchase (such as a sales receipt, purchase invoice, or other evidence admissible under applicable law), please keep your proof of purchase in a safe place.
For this guarantee to apply, the product you purchased must be new, it will not apply to second-hand or display products. Unless stated otherwise by applicable law, any replacement product issued under this guarantee will only be guaranteed until the expiry of the original period guarantee period.
This guarantee covers product failures and malfunctions provided the product was used for the purpose for which it is intended and subject to installation, cleaning, care, and maintenance under the information contained in these terms and conditions, in the user manual and standard practice, provided that standard practice does not conflict with the user manual.
This guarantee does not cover defects and damage caused by normal wear and tear or damage that could be the result of improper use, faulty installation or assembly, neglect, accident, misuse, or modification of the product.
Unless stated otherwise by applicable law, this guarantee will not cover, in any case, ancillary costs (shipping, movement, costs of uninstalling and reinstalling, labor, etc), or direct and indirect damage.
If the product is defective, we will replace or refund, it within a reasonable time.
Rights under this guarantee are enforceable in the country in which you purchased this product. Guarantee-related queries should be addressed to the store you purchased this product from.
The guarantee is in addition to and does not affect your statutory rights.

Installation

IMPORTANT DO NOT USE WITH A DIMMER SWITCH.
IMPORTANT! RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.

Manufacturer

UK Manufacturer: Kingfisher International Products Limited,

1 Paddington Square, London, W2 1GG,

United Kingdom

EU Manufacturer: Kingfisher International Products B.V. Rapenburgerstraat 175E,
1011 VM Amsterdam
The Netherlands
www.kingfisher.com/products
www.diy.com
www.screwfix.com
www.screwfix.ie

Documents / Resources

| Screwfix SL06-2209-B Shipton Single 4ft LED Batten [pdf] Instruction Manual
SL06-2209-B, SL06-2209-W, SL06-4218-B, SL06-4218-W, SL06-2209-B Shipton Single 4ft LED Batten, Shipton Single 4ft LED Batten, Single 4ft LED Batten, 4ft LED Batten, LED Batten, Batten
---|---