Rocelco DM3 Premium Triple Monitor Desk Mount Owner’s Manual

Owner’s Manual DM3 Premium Triple Monitor Desk Mount

DM3 Premium Triple Monitor Desk Mount

WARNING!
Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.
CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury.

• Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious personal injury.
• Safety gear and proper tools must be used. This product should only be installed by professionals.
• Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
• Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws
• This product contains small items that could be a choking hazard if swallowed. Keep these items away from children,
• This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, telephone your local distributor for a replacement.
MAINTENANCE: Check that the bracket is secure and safe to use at regular intervals (at least every three months).

Step 1 Installing Pole to Desktop

Option A: Desk Clamp
Option A: Pince de bureau

• Mounts to any surface up to 8.5cm/3.35” thick.

Option B: Grommet Mount

• Remove screw as shown with Allen Key E.
• Remove threaded rod/thumbwheel.
• Position pole (a) on mounting surface on top of grommet Base Piate (B). Secure underside surface with support plate (i) as shown.Thread rod/thumbwheel through surface into bottom of pole.

Step 2 Installing Arm to Pole

• Slide swivel arm (d) down pole and secure with Allen Key (E)
• Cable management clips (C) & (D)

Step 3 Attach Mounting Plate to Monitor

• Monitor with Flat Back
• Monitor with curved or Recessed Back

Step 4 Slide Monitor to Head of Swivel Arm

• Remove security nut
• Replace security nut & secure before engaging swivel feature

Step 5 Adjust as Needed

• Adjust and tighten bolt with supplied
  Allen Key (E) to desired tilt angle

• Use Allen Key E to raise and lower screens, to level side by side.

• If one monitor is lower, turn the bolt counter-clockwise with supplied Allen key(E) to raise. Install the nut after adjustment.

Step 6 Organize Cable Management

• Use Allen Key (E) to make necessary djustments
• Hold wires in place with cable management clips (C)

Email customerservice@rocelco.com for questions or concerns

Parts List

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>