Rocelco R EDRB Electric Standing Desk Converter Instruction Manual
- June 16, 2024
- Rocelco
Table of Contents
Rocelco R EDRB Electric Standing Desk Converter
Product Information
Specifications
- Grommet hole for optional R DM2 Monitor Arm
- Tools required: Phillips screwdriver
- Part 3: M5*10mmx2pcs
- Part 4: x1
- Part 5: M5*12mmx4pcs
- Part 6: M5*10mmx6pcs
- Part 7: x2
- Part 8: x2
Product Usage Instructions
Step 1: Attaching the Safety Bracket
- Using a Phillips screwdriver, take part 3 (M5*10mmx2pcs) and attach it to the rear upside of the keyboard tray.
- Attach part 4 (safety bracket) to the previously attached part 3 as shown in the diagram.
Step 2: Power Button Installation
- Fixez le bouton d’alimentation (attach the power button) to the designated location.
Step 3: Additional Attachments
- Use part 5 (M5*12mmx4pcs) to attach any additional attachments or accessories to the product.
- For further stability, use parts 6 (M5*10mmx6pcs) and 7 (x2) to secure the product.
- Attach parts 8 (x2) as needed.
FAQ (Frequently Asked Questions)
- Q: What tools are required for assembly?
A: A Phillips screwdriver is required for assembly.
Parts List
Tools required: Phillips screwdriver
DIMENSION
INSTRUCTION
Read the entire instruction manual before you start installation and assembly.
- If you do not understand the instructions or encounter any questions or problems, please contact Rocelco (customerservice@rocelco.com)
- Caution: This can result in serious injury, death or property damage if not assembled or installed properly.
- Do not assemble or install products or accessories if they are damaged or missing. If you need to replace parts, please contact Rocelco (customerservice@rocelo.com)
- Rocelco is not responsible for desktop damage due to load or accident.
- The manufacturer declares that it shall not be liable for any damage or damage caused by any modification or improper installation of the product, or installation beyond the specified weight-bearing range of the product, or improper use of the product, or wear or damage caused by use of the product.
- Carefully read all instructions before attempting installation.
WARNING
PINCH POINT
DO NOT place hands on or near support bars. Pinch points are created during
the lifting and lowering the work surface. Failure to follow these
instructions may result in serious personal injury.
INSTALLATION
- STEP 1:
- Please remove tie strap before plugging in power cord.
- Place REDRB on flat surface and plug in power cord. Raise to highest level using controller shown in diagram.
- Using part 5 (M5*12mmx4pcs) attach power button to the underside of table top (shown in diagram above)
- STEP 2:
- Using part 3 (M5*10mmx2pcs) attach part 4 safety bracket to rear upside of keyboard tray as shown.
- Attach keyboard tray as shown in diagram using part 6 (M5*10mmx6pcs).
Fully assembled and ready to use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>