Enthuze 2021-2023 Ford Bronco 4 Door Side Steps Installation Guide
- June 16, 2024
- ENTHUZE
Table of Contents
ENTHUZE SIDEBARS
2021 FORD BRONCO 4DR
PARTS LIST:
| 1 | Driver/Left PNC Sidebar | 12 | 10mm x 30mm Hex Bolts |
|---|---|---|---|
| 1 | Passenger/Right PNC Sidebar | 12 | 10mm Lock Washers |
| 2 | Front Mounting Brackets | 12 | 10mm x 27mm OD x 3mm Flat Washers |
| 4 | Center/Rear Mounting Brackets | 12 | 8mm x 25mm Combo Bolts |
PROCEDURE:
-
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
-
Starting from underneath the Passenger/Right body panel, locate the front mounting location and the threaded holes in the body panel, (Figure 1). Remove the plastic plugs covering the holes.
-
Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket to the front location with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Figure 2). Do not tighten hardware.
-
Repeat Steps 2 & 4 to attach (2) Center/Rear Mounting Brackets to the center and rear locations, (Figures 3—5). Do not tighten hardware.
-
Select the Passenger/Right PNC Sidebar. Place the Sidebar onto the cradles of the Mounting Brackets.
IMPORTANT: Do not rotate or slide the Sidebar front to back or damage to the finish may result. Attach the Sidebar to the Mounting Brackets with (6) 8mm Combo Bolts, (Figure 6). Do not tighten hardware. -
Level and adjust the PNC Sidebar and tighten all hardware.
-
Repeat Steps 1—7 to attach the Driver/Left PNC Sidebar.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Sidebars.
Passenger/Right side Installation Pictured
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>