SECOP 105N496x Series NLV Compressors Controllers Instructions
- June 16, 2024
- SECOP
Table of Contents
SECOP 105N496x Series NLV Compressors Controllers Instructions
Product Information
Specifications
- Product Name: NLV Compressors 100-240V 50/60Hz 105N496x Series
- Model Number: 8238-67
- Controllers: FRQ-TX RX GND GND DI V+ RL2 RL1 N
- Defrost: LSW 105N4960
- Mains Voltage: 100-240V
- Frequency: 50/60Hz
- Thermostat: AEO mode
- Condenser Fan: N LS
- Interface: Single wire interface (SWI) Modbus protocol
Installation Instructions
How to Fix
Service/Repair R290
Product Usage Instructions
Brazing on Suction Connectors (Direct Intake)
When brazing on suction connectors for compressors with direct suction
intake, ensure a minimum airflow of 3 m/s. Refer to the Product Bulletin for
detailed instructions.
Warning
Airflow Operating Conditions
The compressor operates optimally under the following airflow conditions:
- Airflow Speed: Minimum 3 m/s
Storage Conditions
Ensure the compressor is stored under the following conditions:
- Temperature: Refer to the Product Bulletin for specific storage temperature range
Supply Voltage and Frequency
The compressor is designed to operate with the following electrical specifications:
- Voltage: 100-240V
- Frequency: 50/60Hz
- Input Power: Maximum power consumption should not exceed the specified limit
Interface
The compressor utilizes a single wire interface (SWI) Modbus protocol for communication.
Secop accepts no responsibility for possible errors in catalogs, brochures, and other printed material. Secop reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary to specifications already agreed. All trademarks in this material are the property of the respective companies. Secop and the Secop logotype are trademarks of Secop GmbH. All rights reserved. www.secop.com
FAQ
-
Q: Can I use the compressor with a different voltage?
A: No, the compressor is designed to operate within the specified voltage range of 100-240V. -
Q: What is the recommended airflow speed for brazing on suction connectors?
A: The minimum recommended airflow speed for brazing on suction connectors is 3 m/s. -
Q: Where can I find more detailed instructions?
A: For detailed instructions, please refer to the Product Bulletin provided by the manufacturer.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>