Screwfix Purmo Underfloor Heating Staple Pack 20m² Instruction Manual

Screwfix Purmo Underfloor Heating Staple Pack 20m² Instruction Manual

Getting to Know your CLEVER Thermostat

Turning your CLEVER, ON/OFF

While OFF, your CLEVER will not perform any of its functions.

PLEASE NOTE: Frost Protection will also be inactive.

Hold for 3 seconds to turn the CLEVER on, or off.

Setting the Time and Date

Programming Modes

7 Day (07) – This mode allows you to programme all 7 days of the week individually.
5 day & 2 day (52) – This mode allows you to programme Monday to Friday, and Saturday to Sunday individually. 24hr (24) – This mode allows you to create a single programme which will repeat on a daily basis.

To Select the Programming Mode

Programming Logic

When programming this thermostat you will be asked to enter a time and then the temperature you require at that time. You can set 4 time/ temperature switches through a single day.

E.g. 07:00 & 22°C > 10:00 & 18°C > 15:00 & 22°C > 22:00 & 18°C

With these temperature settings, the heating will be increased to 22°C by 07:00 and maintain that temperature until 10:00 when the temperature requirement will switch to 18°C, this new temperature will be maintained until 22°C is required at 15:00, 22°C will be maintained until 22:00 when only 18°C is required. This last time setting will maintain the specified temperature until 07:00 the next morning*.

*Description simplified for clarity. Building, heat up & cool down rates are not explained here, and will vary according to various external parameters.

To Enter the Programme Parameters

Manual Override

Locking and Unlocking your CLEVER

Advanced Settings List

1. Boost Setting – Hours and Target Temp> 5-35°C
2. Holiday Setting – Days and Target Temp> 5-35°C
3. Sensor Type – 00 Inner Sensor, 01 External Sensor, 02 Inner & External Sensor, Default
4. High Temperature Protection – 35-90°C, Default 90°C
5. Low Temperature Protection – 0-10°C, Default 5°C
6. Swing – 1-9°C, Default 1°C
7. Temperature Calibration ADJ – ±9°C, Default 0°C
8. Highest Target Temperature – 35-90°C, Default 35°C
9. Lowest Target Temperature – 0-30°C, Default 5°C
10. Home Mode – Temperature Setting 5-25°C, Default 22°C
11. Away Mode – Temperature Setting 5-25°C, Default 15°C
12. Sleep Mode – Temperature Setting 5-25°C, Default 18°C
13. Restart Thermostat / Reset Thermostat –

Advanced Settings

Advanced Modes

Your CLEVER thermostat can be set on 6 different modes as shown below:

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>