SAIJI S3E Tablet Stand Holder User Manual
- June 16, 2024
- SAIJI
Table of Contents
TABLET STAND
USER MANUAL
(Model S3E)
Installation
NOTE:
- Screw is screwed on the bottom part of stand.
- You need to twist to remove the screw before install it.
- Insert rod fully into base till it clicks into position
- Insert screw from the base into the rod
- Tighten screw below the base with’r shaped key ( included).
Height Adjustment
Hold the top and pull up the telescopic rod for height adjustment.
Angle Adjustment
Width Adjustment
- Make the clamp perpendicular to the horizontal plane as shown in the figure above.
- Hold the tablet in landscape mode with one hand to push down one side of the clamp.
- At the same time, pull the red string upwards with the other hand to expand the other side of the clamp.
SPECIFICATION
| Model | Stand height | Base diameter | Stand weight | Supports weight |
|---|---|---|---|---|
| S3E | 11.4-18.1 inch | 6.7 inch | 2 lbs | Max 2.2 lbs |
| Holds devices | 4.7-12.9 inch screen | |||
| Stand material | ABS , TPE , Aluminum alloy |
*SAIJI and SAIJI logo are registered trademarks of SAIJI INC in the United States and other countries
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>