VIMUKUN X60 Belt Drive Turntable Installation Guide
- June 16, 2024
- VIMUKUN
Table of Contents
VIMUKUN X60 Belt Drive Turntable
ITEMS IN THIS PACKAGE
Upon opening the turntable’s package, check all of the following accompanying items are included.
- Turntable Unit
- Hinge
- Power Adapter
- Platter with Belt
- RCA Cable
- Dust Cover
- 45 RPM Adaptor
- Slip Mat
- Instruction Manual
Please contact VIMUKUN customer service at support@vimukun.com if there is any accessory missing from the package. Please retain the original packaging materials for exchange or return purposes.
MACHINE INSTALLATION
Essential Setup
-
Place the unit on a flat and level surface.The selected location should be stable and free from vibration.
-
lnstall the turntable lid to the hinges.
-
Remove the tie-wrap that is holding the tonearm.
-
lnstall the turntable platter accordingly.
-
Place the plate on the spindle and put a slip mat on it.
-
Remove the cartridge cover.
Check the stylus for damage
-
Connect AC adaptor to the Power Jack of the unit.
- Check that the Tonearm is level before playback.
CARTRIDGE TRACKING FORCE ADJUSTMENT
The record player is shipped with the counterweight of the tonearm adjusted to a balanced state. There is no need to adjust the counterweight if there are no special circumstances. The supplied Counterweight is suitable for cartridges weighing between 3.0-6.0g.
- Remove the stylus protector from the cartridge and tip during the adjustment.
- Rotate the Counterweight clockwise to the cut-off line.
- Rotate carefully only the Tracking Force Dial until the “l” on the scale lines up with the Center Line marked along the top of the tonearm.
- Next, continue rotating the Counterweight until the “2” on the scale lines up with the Center Line marked along the top of the voice coil.After, unlock the tonearm and check that it stll maintains a level balance.
TROUBLESHOOTING
| Problem | Solution |
|---|
The platter doesn’t turn although the unit is switched on:
| • The unit is not connected to the main power supply.
• No power at the outlet.
• Drive belt is not installed or has slipped off.
• The unit automatically switched in standby mode, power OFF and ON again .
No signal through one or other channel or both channels:
| • Speakers muted.
• No connection to the speakers .
• No connection between turntable and amplifier.
• Wire leads not connected to the cart ridge .
Strong hum on player input:
| • Turntable too close to speakers.
• The record player does not support connection to external ampl ers.
Distorted of inconsistent sound from one or both channels:
| • The vinyl record is damaged.
• Needle or cantilever damaged.
• Drive belt overstretched or dirty.
• Platter bearing without oil, dirty or damaged .
•Duston the stylus .
Cannot connect with Bluetooth speaker :
| • The turntable is not in pairing mode.
• Your Bluetooth speaker is not in pairing mode.
• The Bluetooth transmitter has turned off because Bluetooth is not connected in 2 minutes.
CUSTOMER SERVICE
- 12 – months limited warranty
- Lifetime technical support
- support@vimukun.com
