Lightdot LUFO-250 LED High Bay Light Instruction Manual
- June 16, 2024
- lightdot
Table of Contents
**Lightdot LUFO-250 LED High Bay Light Instruction Manual
**
SAFETY INFORMATION
IMPORTANT ：
Read all safety precautions and installation instructions carefully before installing
- Do not install the fixture with power on, also do not operate by wet hands.
- Ensure the fixture is mounted onto a good structurally surface that will support the fixture.
- The fixture is designed for use in 120-277VAC, 50/60Hz.
- Do not install on radiant-heating type ceiling.
WARNING : IF NOT FOLLOW THESE INSTRUCTION MAY LEAD TO A POTENTIALLY FATAL ELECTRICAL SHOCK OR PROPERTY DAMAGE
NOTE: Before installation, connect the mains to test whether the led high bay light are working or not, and then install.
Microwave Sensor
Factory Default| Detection area| Hold Time| Preset brightness|
Waiting time| Light Sensitivity
---|---|---|---|---|---
100%| 1min| 20%| 10S| 150Lux
Remote Control Setting
Note :
- Battery is not included, need to prepare 2 pcs AAA batteries by yourself.
- When command is executed, the led high bay light will turn on and off once, which means the command is successfully set.
Remote control has many functions, if you encounter problems in the process of
use,
or need more remote control, please contact us
Email
address:service@lightdot.com
Accessories:
-
(AA)Pothook:1PC
-
(BB)screw:1PC
-
(CC)Steel wire rope:1PC
Installation Instruction:
-
Turn off the switch and circuit breaker before installing this LED light fixture. Screw the provided pothook(AA) clockwise into the UFO High Bay fixture, then tighten firmly
-
Fixed the pothook to the High Bay Light by tighten screw (BB), Tighten the nut with a tool.
-
Fixed the pothook with screws .
-
Fixed the safety rope to the LED high bay light and ceiling to ensure the fixture safe.
-
Plug into the socket with120-277VAC input voltage. Installation successfully and turn on circuit breaker.