FreeLicht 4 Inch 5CCT LED Recessed Lighting User Manual

FreeLicht 4 Inch 5CCT LED Recessed Lighting User Manual

SAFETY INFORMATION

1. DANGER – Risk of shock- Disconnect power before installation.
2. WARNING – Risk of fire or electric shock. Installation of this retrofit assembly requires a person familiar with the construction and operation of the luminaire’s electrical system and the hazard involved. If not qualified, Do not attempt installation. Contact a qualified person.
3. Suitable for damp locations. For indoor use only.
4. Suitable for Type IC or NON-IC Luminaires.
5. WARNING – To prevent wiring damage or abrasion, Do not expose wiring to edges of sheef metal or other sharp objects.
6. This device is not intended for use with emergency exits.
7. WARNING – Risk of fire or electric shock. Install this kit only in the luminaires that has the construction features and dimensions shown in the photographs and /or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
8. Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
9. The retrofit kit is accepted as a component of a luminaire where the suitability of the combination shall be determined by authorities having jurisdiction. Product must be installed by a qualified electrician in accordance with the applicable and appropriate electrical dodes. The installation guide dose not supersede local or national regulations for electrical installations.

HOW TO INSTALL

Turn Power OFF

1. Turn off circuit breaker that provides power to the light switch for the recessed lights.

2. Thread the Socket Adapter into the socket.

3. The toggle switch to the specified color temperature.

4. Plug the female connector of the retrofit trim onto the male connector of the housing.

5. Push the connected down light vertically upwards into the can. Tuck all wires into the can and carefully push the retrofit trim into can (Note: to provide enough room in shallow cans carefully position SOCKET ADAPTER and SOCKET adjacent to the side of the LED DRIVER prior to inserting the RETROFIT TRIM into the CAN).

6. Turn on circuit breaker and test light.

PRODUCT INFORMATION

SPECIFICATIONS

Color Temperature: 2700K/3000K/4000K/5000K/6000K 
Watts: 7W
Standard luminous flux: 700LM 
Colour: White 
Default Driver Input: 120V / 60Hz 
CRI: 80
Beam Angle: 120°
Intelligent Dimmer: 5%-100% 
Operating Temp: -4F-104°F

COMMON TROUBLESHOOTING

PROBLEMS AND COUNTERMEASURES

connected
‘The power switch is not turned on| Make sure the power switch is on
‘The light holder in the UL cansis damaged!| Check and replace with a new light holder
Loose connection between E26 adapter and light base| Check the E26 adapter and light holder are. wellinstalled
Loose connection on TP24 connector| Change the TP24 connector
he voltage is too high and the product s damaged| Make sure the voktage is 120V
None of the above.| each out to our Customer Support
Dim| The wire falls off/loosens/breaks| Check the wires are well connected
Incompatible dimmer| Check the dimmer model with the manual
Not setting the dimmer right| Check dimmer settings
Too many lights are connected to one dimmer| Reduce the number of lights connected to a dimmer (the total power of the lights should be less than 75% of the rated power of the dimmer)
The brightness of lighting is too low| Install more lights 4inch: 2-4ft; 6inch: 5-7ft
The brightness of lighting is too high| Turn down the dimmer or reduce the number of lights on at the same time
Voltage is too low| Check the voltage to make sure it is 120V
Loose connection between E26 adapter and light base| Check the E26 adapter and light holder are well installed
The light is not installed correctly| Check the installation of the light, to ensure that the springs and other parts are normal
Flickering| The wire falls off/loosens/breaks| Check the wires are well connected
Incompatible dimmer| Check the dimmer model with the manual
Not setting the dimmer right| Check dimmer settings
Too many lights are connected to one dimmer| Reduce the number of lights connected to a dimmer (the total power of the lights should be less than 75% of the rated power of the dimmer)
High-power electrical appliances on the same circuit| Reduce the number of lights light on the same time
Voltage is too low| Check the line voltage to make sure the voltage is 120V
Loose connection between E26 adapter and light base| Check the line voltage to make sure the voltage is 120VCheck the E26 adapter and light holder are well installed
Falls| No C-damp on the can| Replace the can, or install the C-clamp
The can has C-damp but the spring was not fixed in the damp| Re-install
The spring is loose| Reach out to our Customer Support

LIST OF DIMMERS

CONTACT US

1. Log into your Amazon.com account, click “Returns&Orders” on the top-right corner.

2. Find your order in the list and click “View order details”.

3. Click the “store name” following the Sold by, below the product title.
   Delivered yesterday
   

4. Click the yellow button “Ask a question”, on the top-right corner, to contact the seller

Should you experience any issues while operating any of our products, you can directly reach out to our Customer Support via Amazon Orders. Or you can send your inquiry to our Official Customer Support at:
Call us:
+1(888) 850-0939
Monday – Friday from 9: 00 AM – 5: 00 PM (PT)
Contact via Email : support@freelicht.com

CUSTOMER SERVICE

30-Day Return Policy
If you’re not completely satisfied with your purchase, simply return the merchandise via Amazon Orders.
Unused merchandise can be refunded or exchanged within 30 days from the original purchase date.

5-Year Warranty
“We guarantee your product is free from defects in product material and workmanship for five (5) years starting from the date of purchase during normal use of household conditions. If your appliance fails to operate properly within our warranty period, we will arrange a new replacement free of charge and cover all the shipping costs.

Quick Response within 12 Hours
If you are still unable to resolve the issue you are experiencing, please contact us immediately at our support email. It doesn’t matter if the product has been installed, our customer support team will respond within 12 hours and assist you quickly and efficiently. The most efficient way to confirm your problem to us is to attach a video illustrating your product issue.

Should you experience any issues while operating any of our products, you can directly reach out to our Customer Support via Amazon Orders. Or you can send your inquiry to our Official Customer Support at:
support@freelicht.com
+1(888) 850-0939
Monday – Friday from 9:00AM – 5:00PM (PT)

Need a Video Instruction Guide? Please scan the QR code.

If the QR code is invalid, please contact us for the video.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>