UResMed 1015934 Swift Fx Nano Fitting ser Guide
- June 6, 2024
- ResMed
Table of Contents
Fitting Guide
Fitting Guide
Ensure the bottom of the cushion opening aligns with the bottom of your nose
then place the mask over your nose.
Then pull the headgear over your head so it sits midway between ears and eyes.
Adjust the top strap first by pulling the strap through the buckle, one notch
at a time, until the mask is comfortably over your nose.
Do not overtighten.
The back strap should sit just above the ears at the back of the head.
Adjust both fasteners on the fabric back strap at the same time.
Ensure the backstrap sits over your hair.
Ensure mask is comfortably sealed.
Adjust the nasal cushion until it sits comfortably on your nose.
Connect the free end of the short tube assembly to the air tubing of your
device, then turn it on.
Check for leaks and adjust if needed. If any air is leaking out then readjust
the back strap before readjusting the top strap.
Your mask is now ready to use.
Optional Soft Wraps
Wrap each of the soft wraps around either side of the headgear, folding the
top fastener over the lower one.
The soft wraps should be positioned on your cheeks, with the fasteners on the
outside.
Note: For additional information, refer to the Swift FX Nano / Swift FX
Nano for Her Nasal Mask User Guide.
SwiftTM FX Nano
NASAL MASK
Distributed by:
ResMed Corp 9001 Spectrum Center Boulevard San Diego CA 92123 USA.
ResMed (UK) Ltd 96 Milton Park Abingdon Oxfordshire
OX14 4RY UK. See www.resmed.com for other ResMed
locations worldwide.
Swift is a trademark of ResMed Pty Ltd and is registered in U.S. Patent and
Trademark Office. © 2013 ResMed. Specifications may change without notice.
1015934/1 2013-01
ResMed Pty Ltd
1 Elizabeth Macarthur Drive Bella Vista NSW 2153 Australia
Global leaders in sleep and respiratory medicine
www.resmed.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>