ridem S4 Supporto TV Wall Mount Instruction Manual

SUPPORTO TV
wall mount

RDM S4
Instruction Manual

Montage anleitung

Before proceeding with the installation, check the compatibility of the bracket with your TV. The VESA table shows the distance of the holes on the back of the TV. Also evaluate the suitability of the wall where you will apply the bracket. If in doubt, both for the TV mount choice and for its assembly, contact a professional installer.

COMPATIBILITY

VESA is a registered Trademark of the Video Electronics Standards Association

Per maggiori info sulla linea RIDEM e per consultarele condition di garanzia,vistate il site: www.ridem.eu

Recommended tools

Inside the box

1. Place the two vertical brackets (54) on the TV’s back and fix them to the TV holes, using the suitable screws (MA-MB-MC). Refer to the picture to insert correctly the screws into the washers (MD). The TV with the two brackets will be named P3.

2. Position the bracket on the wall and mark the points where to drill the holes. Before drilling make sure that there are no cables or pipes inside the wall.

3. The bracket can only be positioned on masonry walls (not wood). Use the 10mm bit.

4. Using a hammer, gently push the plugs (B) into the holes just made. Take care to insert the anchors flush ‘with the wall.

5. Fix the bracket (P1) to the wall using the included screws. Fasten them first with a screwdriver and then with a wrench.

6. The 52 bracket is pre-assembled, but the other two 3 rods must be added. To do this, remove the & screws from 52, insert the extensions (S3) and tighten the 4 screws you_removed, you will get the second component (P2).

7. Remove the two pre-assembled screws from component P, hook PT to P2, then reapply the screws as shown in the picture. These two screws will allow you to adjust horizontally the TV (point 10}

8. 1. Remove the safety screws and lift the hooks
   2. Hook the TV {P3) to the bracket {P2) positioning it centrally.
   3. Close the hooks and tighten the two safety screws.

9. Once completed the installation to adjust the screen tilting loosen the screws showed in the picture, move the screen at will and tighten again the screws. Use the included wrench (C).

10. If the TV is not aligned unscrew the two screws indicated in picture 1, by means of a bubble level, adjust the horizontal level (pic.2) and then tighten the screws to fix the position (pic.3).

RIDEM line s produced and distributed by: KARMA ITALIANA srl – Via Gozzano 38/bis – 21052 Busto Arsizio – www.karmaitalianait – Made in China 221

www.ridem.eu

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>