WQP052 Tattoo Pen Instructions
- June 15, 2024
- Tattoo
Table of Contents
Tattoo Pen Instructions
Instructions for use
Power on
In the off state, hold down the power button for 1.5 second
Power Off
Hold down the power button for 1.5 seconds
Control output
Press the up key to increase the output voltage. Long press on the build, can
quickly improve the output voltage,
Short press the key to reduce the output voltage. Long press build, can
quickly reduce the output voltage,
LED prompt
When the machine does not output,LED light breathing display.
After the output of the machine is turned on, the LED light is always on
LED prompt
When the machine does not output,LED light breathing display.
After the output of the machine is turned on, the LED light is always on.
Electric quantity
The machine will shut down automatically when the battery is too low.
When the battery is too low, the system will prompt low power and then
automatically shut down.
Bluetooth matching instructions
Step 1: put the machine and foot into the matching mode at the same time
When the machine is turned off, press three buttons on the machine for 1.5
seconds at the same time. The machine enters the matching mode. The Bluetooth
icon flashes on the screen.
In the off state, press the pedal control button and the power button at the
same time for 1.5 seconds, and the pedal enters the matching mode. The LED
light alternates red and green and flashes rapidly.
Step 2: Wait for the match to complete
The matching of the machine to the foot is done automatically. When finished,
the machine will display a success sign. The LED indicator on the foot no
longer flashes rapidly.
Step 3: Boot automatic connection When the match is successful
After the machine and foot start, it will be automatically connected.
When the connection is successful, the Bluetooth icon will appear on the
machine screen. The LED indicator of the foot is on.
FCC Warning Statement: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of
the
FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause ndesired operation.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>