CRITICAL TATTOO CTC-CV3 Critical Torque Pen Machine User Guide
- June 9, 2024
- CRITICAL TATTOO
Table of Contents
CRITICAL TATTOO CTC-CV3 Critical Torque Pen Machine
FEATURES
GRIP OPTIONS
POWER ATTACHMENTS
BATTERY BASICS
LARGE CAPACITY BATTERY
Up to is hours of tattooing
*tattoo duration could change due to battery charge and voltage usage.
DISPLAY LAYOUT
SETTING MENU
| COMMAND | BUTTONS | ACTION |
|---|---|---|
| TO ENTER SETTINGS MENU FROM MAIN MENU | 3 SEC HOLD |
SCROLL UP
SCROLL DOWN| | 1 – CLICK
BACK BUTTON OR RETURN TO MAIN MENU| 
| 2 – CLICK
SETTING DEFINED
CRITICAL CONNECT:
Connect or Disconnect from Bluetooth (Critical Connect footswitch Required)
JUMPSTART:
Turn jumpstart on or off
PEDAL MODE:
If using a footswitch, you can change your output mode on the pedal to either
continuous or momentary power.
TIMER MODE:
You can make your Run/Session timer visible on the main menu or hide it with a play/pause symbol.
BILLING MODE:
if you want to track your session time and/or hourly rate , you can do so two ways. the Session timer will record the entire session from when you manually start the timer and pause it, like a stopwatch . The Run timer will record only when the battery is active and outputting power.
HOURLY RATE:
You can update your hourly charge rate here.
BUTTON LAYOUT:
You can switch your primary buttons to either the Left or Right side to change
the voltages.
SESSION RUN MENU
| COMMAND | BUTTONS | ACTlON |
|---|
TO START /PAUSE TIMER SESSION MODE ONLY
WHIL ON THE MAIN PAGE| 
|
1-CLICK
TO ENTER SESSION /RUN MENU
FROM MAIN PAGE
| | 3 SEC HOLD
TO CLEAR OR RESET THE TIMER
WHILE IN THE SESSION /RUN MENU
| 
| 3 SEC HOLD
TO EXIT SESSION/ RUN MENU
TO RETURN TO MAIN PAGE
| | 2-CLICK
POWER TO THE ARTIST
@CRITICALTATTOOSUPPLY
EMAIL: INFO@CRITICALTATTO.COM
PHONE : 877-271-1446
DESINED IN CALIFORNIA | MADE IN CHINA
US PATENT 10471246, 202030724065.7, 29/736,884 AND OTHER US PATENTS PENDING
FCC ID: 2A3QRCTC-CV3
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions : 1)
this device may not cause harmful interference , and 2) this device must accept any interference received , including interference that may cause undesired operation.
changes or modification not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device . pursuant to Part 15 of the FCC Rules , These
limits are designed to provide this equipment generates uses and can radiate
radio frequency energy and , if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications . However
,there is no guarantee that interference will not occur in reception , which
can be determined by turning the equipment off and on , the user is
encouraged to try to correct the interference by on or more of the following
measures”
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver .
connect the equipment into an outlet on a circuit different from that to which
the receiver is connected .
consult the dealer or an experienced radio/ TV technician help.
The device has been evaluated to meet general RF expose requirement , the device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>