CRITICAL TATTOO Critical Connect Wired Foot Switch Instructions
- June 6, 2024
- CRITICAL TATTOO
Table of Contents
CRITICAL TATTOO Critical Connect Wired Foot Switch Instructions
HOW TO PAIR MULTIPLE BATTERIES
- PAIR 1 ST BATTERY TO FOOT SWITCH
- DOUBLE CLICK “ ” MODE TO ENTER
- TURN ON OR EXIT STANDBY BY DOUBLE CLICKING ON 2ND DEVICE
- PAIR 2ND BATTERY TO FOOT SWITCH
PAIR AND SWITCH BETWEEN UP TO 4 BATTERIES AND 1 FOOT SWITCH
ONLY 1 BATTERY CAN BE OPERATED AT A TIME PER FOOT SWITCH. ALL BATTERIES NOT IN
USE SHOULD BE ON STANDYBY MODE OR OFF
COMPATIBLE PRODUCTS
1 2 MONTH WARRANTY
PATE NT INFO US UTILITY PATENT – 10,471,246 AUSTRALIA UTILITY PATENT – AU 20202009192 US DESIGN PATENT – 29/736,884 CHINA DESIGN PATENT – 202030297770.3 CANADA DESIGN PATENT – 1965E11
VIDEO TUTORIAL
WWW.CRITICALTATTOCI.COM/CRITICALCONNECT
WWW.0 R ITI CA LTATTO 0 . C 0 M
FCC STATEMENT
This device awaphes with Rut 15 of the FCC rules. Operation is subject b the
tbllowin2 two conditions: 1) this device may not cause harmful Intel-femme,
and 2)61sdevice must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the cquipmcm.
NOTE:
This equipment has been tested and found to comply with the limits fora Class B device, pursuant to Part IS of the FCC Rules. These limits are designed to provide reasonable pmtection against harmful interference m a residential installation. This equipment generates uses and can mkt radio frequency ertrgy and, if not installed and used n accordance with the instnxticaz, may cause harmful interferences to radio commumations. However, there is no guarantee tat interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can lx-ddernunai by timing the equipment ottani on, the user is encouraged to try to correct the interkrence by one or mow of the following measures: Reorient or rdocate the receivine antenna. Increase the separation between the equipment and receiver. Conned the equipment into an outlet on a circuit di tie re nt from that to WI is h the receiver is connected. Consult the dealer or an exixnenced radihrlY technician for trip.