eldom HC210 Convector Heater with Turbo Function Instruction Manual

: June 4, 2024
: ELDOM

Table of Contents

HC210 Convector Heater with Turbo Function
SAFETY RECOMMENDATIONS
OPERATING INSTRUCTION
INSTALLATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Convector Heater with Turbo Function
Instruction Manual

eldom HC210 Convector Heater with Turbo Function -

HC210 Convector Heater with Turbo Function

The disposal of used electrical and electronic equipment (applies to European Union countries and other European countries with separate waste-collection systems).
This symbol on the product or its packaging indicates that it should not be classified as household waste. It should be handed over to an appropriate company dealing with the collection and recycling of electrical and electronic equipment. The correct disposal of the product will prevent potential negative consequences for the environment and human health resulting from hazardous substances present in the product. Electrical devices must be handed over to restrict their re-use and further treatment. If the device contains batteries, remove them, and hand them over to a storage point separately. DO NOT THROW EQUIPMENT INTO THE MUNICIPAL WASTE BIN. Material recycling helps to preserve natural resources. For detailed information on how to recycle this product, please contact your local authority, the recycling company, or the shop where you bought it.

SAFETY RECOMMENDATIONS

Read thoroughly this manual before the first use of the unit. Failure to comply with the following safety and safety instructions may result in electric shock, fire and/or serious injury. Keep all warnings and security notices so you can use them in the future.

The heater is not designed for use in bathrooms, washrooms or other damp areas. Set the heater on so that the unit in water tank (bath, .) or the like may fall.
The device should be connected to the power supply grid compatible with the current parameters stated on the enclosure.
Always disconnect the device from the power supply before cleaning and maintenance, in case of abnormal operation and after its use.
Always disconnect the device from the power supply by pulling the plug, and not the power supply cord.
The device must not be immersed in water or sprinkled.
Do not operate the device close to flammable objects like furniture, bedclothes, paper, clothing, curtains, carpets, etc., and materials that may be deformed.
Do not use in rooms of increased risk of gas explosion and where flammable solvents, enamels or adhesives are used.
The noise after turning on / off of the unit is normal.
Do not use in open air.
The unit must be installed, operated, and stored in a room bigger than 5 m2
Keep a safe distance from 1 m around the device a.
Use only in a vertical position.
Do not touch the device with wet or moist hands or feet.
Handle the device only by the handle.
Do not allow children or animals to access the device. During the operation of the device, the temperature of the surface of the heater may be quite high.
Do not cover the device with clothing and other textiles when in use.
Do not use the device to dry clothing.
Do not run the power supply cord above the heater and exhaust openings of warm air.
This equipment may be used by children of at least 8 years old and by persons with reduced physical and mental capacity and persons with no experience and knowledge of the equipment if supervision or instruction is provided for use of the equipment in a safe way, so that the related hazards are understandable. children should not play with the equipment. children without supervision should not clean and maintain the equipment.
Keep the device and cable away from children.
The device must not be left operating without supervision.
When the device is not used, disconnect it from the power supply source.
Leave the device to cool down before putting it into storage.
Check regularly whether the power supply cord and the whole device are not damaged. The device must not be switched on if any damages are detected.
Never use the unit when the power cord is damaged or when the device was dropped or damaged in any way.
The device is filled with the exact amount of special oil.
If any oil is leaking, contact the service point.
The device may only be opened and repaired by a specialist.
Only an authorized service point can repair the equipment. The list of the service points is provided in the annex and in the website www.eldom.eu, Any modernizations or use of non-original spare parts or elements of the device is forbidden and threatens the safety of its use.
Eldon Sp. z o.o. shall not be responsible for any damages resulting from improper use of the device.

WARNING: The free air outlet must not be affected. Therefore, the upper and grilles of the unit may not quite yet be partially covered for safety reasons. THIS PRODUCT IS ONLY SUITABLE FOR WELL-INSULATED SPACES OR OCCASIONAL USE. WARNING: Plastic bags can be dangerous, to avoid the danger of suffocation keep these bags away from babies and children.

OPERATING INSTRUCTION

GENERAL DESCRIPTION

eldom HC210 Convector Heater with Turbo Function - Fig
1

Ventilation openings
Handle
Supply switch (operation mode)
Indicator light power
Thermostat
Feet

TECHNICAL DETAILS
Rated power: 1800-2000W
Mains supply:
220-240V ~ 50-60Hz

INTENDED USE
Convector with blower for heating individual rooms (offices, living rooms, etc.). The device is easily portable and therefore ideal for transitional heating. The natural connection is intensified by the blower switchable as needed. He stands firmly on stable feet. At the temperature selector, the desired room temperature is continuously adjustable.
USING THE DEVICE

After unpacking the device, make sure if it was not damaged during the transport. In case of any doubts, refrain from its use until contacting a service point.
Install the feet (6) – pic. 2.
Place the unit on a flat, stable and heat-resistant floor, min. 2 m away from furniture and flammable objects.
Set the thermostat (5) in the “MIN” position.
Connect the device to the power supply source of the parameters compliant with those stated in the user guide.
Using the switch (3) select the heating power: – ” I” for 1250W + TURBO – ” II” for 2000W+ TURBO – “I” for 1250W – “II” for 2000W
The device will start when the temperature is selected with the thermostat knob (5). The maximum operating temperature is set when the thermostat button (5) is set to “MAX” and the heating level ” II” is selected.
Operation of the device is signaled with the indicating lamp (4).
During the operation of the device, do not cover the heater with clothing or other textiles.
Do not cover ventilation openings.
The device has a thermal safeguard cutting off the power supply when it is overheated. In this case, set the thermostat knob in the “MIN” position, disconnect the device from the power supply and eliminate the cause of overheating. Leave the device to cool down before switching the device on again.

INSTALLATION

Carefully place the device with its feet upwards (soft surface is best used to avoid damaging of the protection coat).
Install the feet – pic. 2.
Turn the heater back to the proper vertical position.

eldom HC210 Convector Heater with Turbo Function - Fig
2

CLEANING AND MAINTENANCE

Disconnect the device from the power supply before cleaning.
The device must not be immersed in water.
Do not use cleaning agents and products that are strong or destructive to the surface.
Wipe the enclosure with a damp cloth.

PROTECTION OF THE ENVIRONMENT

The device is made of materials that may be subjected to further processing or recycling.
It should be handed over to the relevant point dealing with the collection and recycling of electrical and electronic devices.

GUARANTEE

The device is intended for private household use.
It may not be used for professional applications.
The guarantee shall become void if the device is operated improperly.

Table|

A model identifier for electric local space heaters

---|---
Model number:| HC210
Item| Symbol| Value| Unit
Heat output
Nominal heat output| PK.,| 1,9| kW
Minimum heat output (indicative)| Prntri| 1,2| kW
Maximum continuous heat output| Prnax•c| 1,9| kW
Auxiliary electricity consumption
At nominal heatoutput| elmax| 0| kW
At minimum heatoutput| Elgin| 0| kW
In standby mode| else| 0| kW
Type of heat input, for electric storage local space heaters only (single select)
manual heat charge control, with integrated thermostat| Yes No
manual heat charge control with room and/or outdoor temperature feedback| Yes No
electronic heat charge control with room and/or outdoor temperature feedback| YesNo
fan assisted heat output| al YesNo
Type of heat output/room temperature control (single select)
single stage heat output and no room temperature control| YesNo
Two or more manual stages, no room temperature control| U Yes No
with mechanic thermostat room temperature control| Yes No
with electronic room temperature control| ❑Yes ****No
electronic room temperature control plus day timer| ❑Yes No
electronic room temperature control plus week timer| No ❑Yes
Other control options (multiple selections possible)
room temperature control, with presence detection| ❑YesNo
room temperature control, with open window detection| ❑Yes No
with distance control option| ❑Yes No
with adaptive start control| ❑Yes No
with working time limitation| ❑Yes No
with black bulb sensor| ❑Yes No
Contact details| Eldon Sp. z o.o. Pawla Chromika 5a, 40-238 Katowice, POLAND tel: +48 32 2553340 , fax: +48 32 2530412