YOYOJAMES Y-N381 Solar Remote Ceiling Lamp User Manual
- June 15, 2024
- YOYOJAMES
Table of Contents
YOYOJAMES Y-N381 Solar Remote Ceiling Lamp User Manual
Product Accessory
Parameter
| Solar panel | 6V*3W monocrystalline silicon solar panel |
|---|---|
| LED | 120pcs 2835LED |
| Switch function | A: 24H motion sensor lighting, B: Night motion sensor |
lighting ,
C: Sensor hight lighting + dim lighting, D:intelligent light control
Material| ABS
Charging mode| Solar charging/DC charging
Charging time| 6-8hrs (affected by the light intensity in different seasons)
Working time (Full power)| Mode A and B motion sensor lighting >100times,C:
dim lighting >24H, alight control>8H
Cable length| 5meters enviromental cold-proof cable
Waterproof rate| IP55
Battery| 3.7V*4000mAH Lithium battery
Remote distance| 6-10meters
Motion distance| 3-6 meters (affected by ambient temperture and installation
height)
Charging efficiency will be affected the light intensity in different seasons, The charging time of manual is based on summer.
Installation
-
Install solar panel base
-
Fix solar panel and adjust angle, connect cable
Remote
Notice: Before using the remote ,please remove the battery isolation piece at the bottom of remote. When don’t use, you’d better not to insert the isolation piece back into the remote, avoiding to affect the battery lifespan
Manual Switch Instructions
Press once：Same as “A”mode
Press twive：Same as “B”mode
Press three times: Same as “C”mode
Press four times: Same as “D”mode
Press five times : Power off
Attention:
- Avaliable temperature:-10℃ ~ +50℃
- If not use for a long time ,please chrage it each 3 months,otherwise will affect battery lifespan
- You’d better to install in open area and can be charged 6-8Hrs in direct sunshine each day
- Please keep the solar panel clean, avoild the leaves, trees and others obstacles,otherwise will affect charging efficiency
- Please avoid to high light illuminate on the solar panel at night, otherwise will not work
- Don’t install product near signal tower or electromagnetic field ground,will cause interference
- Don’t using the lamp in high temperature, humidity, corrosive environment otherwise it will effect the product of lifespan.
- Please adjust the solar panel to face to sunshine.
- When the remote is not sensitive or distance is short, or battery power is low, need to replace battery.
- Using the remote need to align with the light source surface, such as offset angle or shielding and distance too far, will affect the use of remote control.
- Product has memory function, that is ,each day the lightwill work according to the last setting function, pressing “OFF” will cancel the memory function.
- Anything moving near or above human body temperature will trigger infrared sensors
- When using DC charging, only allow DC5V*<2A, and the charging time should be <3 hours. if use the other parameters charger or charge too long time may cause safety hazards.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>